In situ heating SEM observation of the bainitic transformation process in Cu-17Al-11Mn (at.%) alloys

被引:12
作者
Motomura, Shunichi [1 ]
Soejima, Yohei [1 ]
Miyoshi, Takayuki [1 ]
Hara, Toru [2 ,3 ]
Omori, Toshihiro [4 ]
Kainuma, Ryosuke [4 ]
Nishida, Minoru [3 ]
机构
[1] Kyushu Univ, Interdisciplinary Grad Sch Engn Sci, Dept Appl Sci Elect & Mat, Kasuga, Fukuoka 8168580, Japan
[2] Natl Inst Mat Sci, Adv Key Technol Div, Surface Phys & Struct Unit, 1-1 Namiki, Tsukuba, Ibaraki 3050044, Japan
[3] Fac Engn Sci, Dept Engn Sci Elect & Mat, Kasuga, Fukuoka 8168580, Japan
[4] Tohoku Univ, Grad Sch Engn, Dept Met Mat Sci & Mat Proc, Aoba Ku, Aoba Yama 02, Sendai, Miyagi 9808579, Japan
关键词
in situ electron microscopy; scanning electron microscopy; Ar ion milling; bainitic transformation; martensitic transformation; Cu-Al-Mn alloy; CU-ZN; MARTENSITE;
D O I
10.1093/jmicro/dfv363
中图分类号
TH742 [显微镜];
学科分类号
摘要
To understand the bainitic transformation behavior in Cu-17Al-11Mn (at.%) alloys, dynamic in situ observation during heating was carried out in a scanning electron microscope (SEM). In this study, after optimizing the sample preparation method and observation conditions, we successfully observed the transformation process with sufficient resolution and contrast. From the observation results, bainite is first formed preferentially at the grain boundaries of the parent phase. Bainite is also formed inside the grains to relax the elastic strain generated by the initial bainite. Regarding the growth mode, in the early stage of the transformation, bainite grows along the longitudinal direction, and in the late stage, it grows along the lateral direction. The growth rate of the bainite was also evaluated by continuous observation of the same plate. Dynamic in situ observation of a martensitic transformation in the same alloy was also performed to compare the growth mode with that of bainite, and it was found that the behavior is considerably different between bainitic and the martensitic transformations.
引用
收藏
页码:159 / 168
页数:10
相关论文
共 24 条
[1]  
Aaronson H I, 1965, SPECIAL REPORTS IRON
[2]   THE CRYSTALLOGRAPHY AND BOUNDARY STRUCTURE OF INTERPLATE-GROUP COMBINATIONS OF 18R MARTENSITE VARIANTS IN CU-ZN-AL SHAPE MEMORY ALLOYS [J].
ADACHI, K ;
PERKINS, J ;
WAYMAN, CM .
ACTA METALLURGICA, 1988, 36 (05) :1343-1364
[3]   In Situ Optical Microscope Study of the Thermally Induced Displacive Transformations in Cualni-Based Shape-Memory Alloys [J].
Benke, M. ;
Mertinger, V. .
JOURNAL OF MATERIALS ENGINEERING AND PERFORMANCE, 2014, 23 (07) :2333-2338
[4]  
Christian J.W., 1965, THEORY TRANSFORMATIO, V1st
[5]  
Clark H.M., 1970, PHASE TRANSFORMATION
[6]  
GARWOOD RD, 1954, J I MET, V83, P64
[7]  
Hehemann RF, 1970, PHASE TRANSFORMATION
[8]   In situ measured growth rates of bainite plates in an Fe-C-Mn-Si superbainitic steel [J].
Hu, Zhang-wei ;
Xu, Guang ;
Hu, Hai-jiang ;
Wang, Li ;
Xue, Zheng-liang .
INTERNATIONAL JOURNAL OF MINERALS METALLURGY AND MATERIALS, 2014, 21 (04) :371-378
[9]   HIGH-RESOLUTION, LOW-VOLTAGE SEM FOR TRUE SURFACE IMAGING AND ANALYSIS [J].
JAKSCH, H ;
MARTIN, JP .
FRESENIUS JOURNAL OF ANALYTICAL CHEMISTRY, 1995, 353 (3-4) :378-382
[10]   Thermoelastic martensite and shape memory effect in ductile Cu-Al-Mn alloys [J].
Kainuma, R ;
Takahashi, S ;
Ishida, K .
METALLURGICAL AND MATERIALS TRANSACTIONS A-PHYSICAL METALLURGY AND MATERIALS SCIENCE, 1996, 27 (08) :2187-2195