The use of high calcium wood ash in the preparation of Ground Granulated Blast Furnace Slag and Pulverized Fly Ash geopolymers: A complete microstructural and mechanical characterization

被引:91
作者
Cheah, Chee Ban [1 ]
Samsudin, Muhammad Hasnolhadi [1 ]
Ramli, Mahyuddin [1 ]
Part, Wei Ken [1 ]
Tan, Leng Ee [1 ]
机构
[1] Univ Sains Malaysia, Sch Housing Bldg & Planning, George Town 11800, Malaysia
关键词
High calcium wood ash; Hybrid industrial by-products; Low alkaline activator geopolymer; Ambient temperature curing; Geopolymer mortar; EARLY STRENGTH PROPERTIES; CONCRETE; CEMENT; OPC; REPLACEMENT; WORKABILITY; COMBUSTION; ACTIVATOR; AGGREGATE; BEHAVIOR;
D O I
10.1016/j.jclepro.2017.04.026
中图分类号
X [环境科学、安全科学];
学科分类号
08 ; 0830 ;
摘要
As concern regarding global environmental issue grows, there is an emerging interest to substitute conventional ordinary Portland cement by using geopolymer composite as binder matrix in concrete. However, there are two main components that become a barrier in industrialization of geopolymer are the high content of chemical activator and requirement for post fabrication heat treatment which is an energy intensive process. The study investigate the hybridization of three industrial byproducts namely Ground Granulated Blast Furnace Slag, High Calcium Wood Ash and Pulverized Fly Ash activated with reduced level of alkaline activator and produced without any thermal treatment and possesses adequate mechanical performance mortar for industrial application. Besides, the properties of low energy hybrid geopolymer mortar were assessed based on the mechanical and microstructure aspects. Test specimens were evaluated in terms of standard consistency, setting times, compressive strength, flexural strength, ultrasonic pulse velocity, dynamic modulus of elastic, and microstructure development. The inclusion of Pulverized Fly Ash at the content of 10-60% by binder weight does reduce the water demand and significantly prolonged the setting times of hybrid geopolymer paste. Enhanced modulus of elasticity, ultrasonic pulse velocity, compressive and flexural strength were observed for hybrid geopolymer concrete with Pulverized Fly Ash content of 40-80% by binder weight compare to control mixture, 0% PFA. Besides, from Scanning Electron Microscope micrograph and Energy Dispersive X-ray analysis geopolymer paste matrix indicated the formation of geopolymeric products of C-A-S-H and N-A-S-H that contributes to the early strength development on geopolymer mixture contains 0% up to 60% percentage of Pulverized Fly Ash. (C) 2017 Elsevier Ltd. All rights reserved.
引用
收藏
页码:114 / 123
页数:10
相关论文
共 40 条
[21]   Use of OPC to improve setting and early strength properties of low calcium fly ash geopolymer concrete cured at room temperature [J].
Nath, Pradip ;
Sarker, Prabir Kumar .
CEMENT & CONCRETE COMPOSITES, 2015, 55 :205-214
[22]   Effect of GGBFS on setting, workability and early strength properties of fly ash geopolymer concrete cured in ambient condition [J].
Nath, Pradip ;
Sarker, Prabir Kumar .
CONSTRUCTION AND BUILDING MATERIALS, 2014, 66 :163-171
[23]   Synthesis of heat and ambient cured one-part geopolymer mixes with different grades of sodium silicate [J].
Nematollahi, Behzad ;
Sanjayan, Jay ;
Shaikh, Faiz Uddin Ahmed .
CERAMICS INTERNATIONAL, 2015, 41 (04) :5696-5704
[24]   Influence of recycled aggregate on fly ash geopolymer concrete properties [J].
Nuaklong, Peem ;
Sata, Vanchai ;
Chindaprasirt, Prinya .
JOURNAL OF CLEANER PRODUCTION, 2016, 112 :2300-2307
[25]   Effect of synthesis parameters on the mechanical properties of fly ash-based geopolymers [J].
Panias, Dimitrios ;
Giannopoulou, Ioanna P. ;
Perraki, Theodora .
COLLOIDS AND SURFACES A-PHYSICOCHEMICAL AND ENGINEERING ASPECTS, 2007, 301 (1-3) :246-254
[26]   The setting time of a clay-slag geopolymer matrix: the influence of blast-furnace-slag addition and the mixing method [J].
Perna, Ivana ;
Hanzlicek, Tomas .
JOURNAL OF CLEANER PRODUCTION, 2016, 112 :1150-1155
[27]  
Pesonen J, 2016, REV ROM MATER, V46, P82
[28]   High calcium fly ash geopolymer mortar containing Portland cement for use as repair material [J].
Phoo-ngernkham, Tanakorn ;
Sata, Vanchai ;
Hanjitsuwan, Sakonwan ;
Ridtirud, Charoenchai ;
Hatanaka, Shigemitsu ;
Chindaprasirt, Prinya .
CONSTRUCTION AND BUILDING MATERIALS, 2015, 98 :482-488
[29]   X-ray microtomography shows pore structure and tortuosity in alkali-activated binders [J].
Provis, John L. ;
Myers, Rupert J. ;
White, Claire E. ;
Rose, Volker ;
van Deventer, Jannie S. J. .
CEMENT AND CONCRETE RESEARCH, 2012, 42 (06) :855-864
[30]   Role of slag in microstructural development and hardening of fly ash-slag geopolymer [J].
Puligilla, Sravanthi ;
Mondal, Paramita .
CEMENT AND CONCRETE RESEARCH, 2013, 43 :70-80