Finite Element Analysis of sheet metal bending process to predict the springback

被引：78

作者：

Panthi, S. K. ^{[1
]}

Ramakrishnan, N. ^{[2
]}

Ahmed, Meraj ^{[1
]}

Singh, Shambhavi S. ^{[1
]}

Goel, M. D. ^{[1
]}

机构：

[1] AMPRI, Bhopal 462064, India

[2] Indian Sci Lab, GM, Bangalore 560066, Karnataka, India

来源：

MATERIALS & DESIGN | 2010年 / 31卷 / 02期

关键词：

Springback; Sheet metal forming; Minimal load condition; NUMERICAL-SIMULATION; STRAIN; OPTIMIZATION; DESIGN; MODEL;

D O I：

10.1016/j.matdes.2009.08.022

中图分类号：

T [工业技术];

学科分类号：

08 ;

摘要：

Springback remains a major concern in sheet metal forming process. Springback, shape discrepancy between fully loaded and unloaded configuration due to elastic recovery of material, is mainly affected by geometrical parameters, material properties of sheet and lubrication condition between the blank and the tool. A total-elastic-incremental-plastic (TEIP) algorithm, for large deformation and large rotational problems, was incorporated in indigenous Finite Element software. This software was used to predict the springback in a typical sheet metal bending process and to investigate the influence of these parameters on springback. The results of simulation are validated with own experiments and published experimental results. (C) 2009 Elsevier Ltd. All rights reserved.

引用

页码：657 / 662

页数：6

共 38 条

[31] Determining springback amount of steel sheet metal has 0.5 mm thickness in bending dies
Tekaslan, Ö
Seker, U
Özdemir, A
[J]. MATERIALS & DESIGN, 2006, 27 (03) : 251 - 258
[32] An experimental study on the examination of springback of sheet metals with several thicknesses and properties in bending dies
Tekiner, Z
[J]. JOURNAL OF MATERIALS PROCESSING TECHNOLOGY, 2004, 145 (01) : 109 - 117
[33] Investigation of spring-go phenomenon using finite element method
Thipprakmas, Sutasn
Rojananan, Surasit
[J]. MATERIALS & DESIGN, 2008, 29 (08) : 1526 - 1532
[34] Wagoner R. H, 1997, METAL FORMING ANAL
[35] Xu WL, 2004, J MATER PROCESS TECH, V151, P217, DOI 10.1016/j.matprotec.2004.04.044
[36] Mechanism of springback-free bending of high-strength steel sheets under warm forming conditions
Yanagimoto, J.
Oyamada, K.
[J]. CIRP ANNALS-MANUFACTURING TECHNOLOGY, 2007, 56 (01) : 265 - 268
[37] A model of large-strain cyclic plasticity and its application to springback simulation
Yoshida, F
Uemori, T
[J]. INTERNATIONAL JOURNAL OF MECHANICAL SCIENCES, 2003, 45 (10) : 1687 - 1702
[38] An analytical model for predicting springback and side wall curl of sheet after U-bending
Zhang Dongjuan
Cui Zhenshan
Ruan Xueyu
Li Yuqiang
[J]. COMPUTATIONAL MATERIALS SCIENCE, 2007, 38 (04) : 707 - 715

← 1 2 3 4 →