Evidence of Proton Transport in Atomic Layer Deposited Yttria-Stabilized Zirconia Films

被引:49
作者
Park, Joong Sun [1 ]
Kim, Young Beom [1 ]
Shim, Joon Hyung [1 ,3 ]
Kang, Sangkyun [4 ]
Guer, Turgut M. [2 ]
Prinz, Fritz B. [1 ,2 ]
机构
[1] Stanford Univ, Dept Mech Engn, Stanford, CA 94305 USA
[2] Stanford Univ, Dept Mat Sci & Engn, Stanford, CA 94305 USA
[3] Korea Univ, Dept Mech Engn, Seoul, South Korea
[4] Samsung Elect, Samsung Adv Inst Technol, Giheung, Gyeonggi Do, South Korea
关键词
OXIDE FUEL-CELLS; HYDROGEN DIFFUSION; TEMPERATURE; PERFORMANCE; MEMBRANES; ELECTROLYTES; CONDUCTIVITY; DEGRADATION; FABRICATION; CERAMICS;
D O I
10.1021/cm1017536
中图分类号
O64 [物理化学(理论化学)、化学物理学];
学科分类号
070304 ; 081704 ;
摘要
This study presents spectroscopic and electrochemical evidence that verifies proton transport in the temperature regime 300-450 degrees C in yttria-stabilized zirconia (YSZ) thin film membranes fabricated by atomic layer deposition (ALD). High-resolution X-ray photoelectron spectrometry (XPS) of Ols showed that the OH peak was significantly more pronounced in A LID samples than in single-crystal YSZ. Similarly, secondary ion mass spectrometry (SIMS) measurements, conducted for comparison on single-crystalline YSZ and atomic layer deposited YSZ, indicated that ALD YSZ contains MO times higher deuterium concentration than single crystalline YSZ. Si MS depth profiles suggested diffusion of protons through protonic defects in YSZ. We have also fabricated fuel cells employing ALD YSZ with dense palladium layers to block oxygen but allow hydrogen transport. These performed as protonic fuel cells at intermediate temperatures achieving 10 mW/cm(2) at 450 degrees C. These results open the possibility to engineer ALD YSZ as electrolyte membranes for new protonic devices operating at relatively low temperature regimes.
引用
收藏
页码:5366 / 5370
页数:5
相关论文
共 50 条
[31]   Effect of Rate on Pulsed Laser Deposition of Yttria-Stabilized Zirconia Electrolyte Thin Films for SOFCs [J].
Mukai, T. ;
Fujita, T. ;
Tsukui, S. ;
Yoshida, K. ;
Adachi, M. ;
Goretta, K. C. .
JOURNAL OF FUEL CELL SCIENCE AND TECHNOLOGY, 2015, 12 (03)
[32]   Space charge layer evolution at yttria-stabilized zirconia grain boundaries upon operation of solid oxide fuel cells [J].
Chen, Yun ;
Abernathy, Harry ;
Hackett, Gregory ;
Fan, Yueying ;
Lee, Shiwoo ;
Gerdes, Kirk ;
Song, Xueyan .
ACTA MATERIALIA, 2022, 237
[33]   Mechanical and thermal properties of porous yttria-stabilized zirconia [J].
Shimonosono, Taro ;
Ueno, Takuya ;
Hirata, Yoshihiro .
JOURNAL OF ASIAN CERAMIC SOCIETIES, 2019, 7 (01) :20-30
[34]   Controlling the Diameter of Electrospun Yttria-Stabilized Zirconia Nanofibers [J].
Koo, Ja Yang ;
Hwang, Sangyeon ;
Ahn, Minwoo ;
Choi, Mingi ;
Byun, Doyoung ;
Lee, Wonyoung .
JOURNAL OF THE AMERICAN CERAMIC SOCIETY, 2016, 99 (09) :3146-3150
[35]   Impurities Effect on the Charge Mobility of Yttria-Stabilized Zirconia [J].
Abo-Zeid, Menna M. ;
El-Deab, Mohamed S. ;
AbdelKareem, A. ;
El-Kady, Omayma A. M. ;
Daher, A. M. .
INTERNATIONAL JOURNAL OF ELECTROCHEMICAL SCIENCE, 2016, 11 (04) :3137-3146
[36]   Rapid densification of sol-gel derived yttria-stabilized zirconia thin films [J].
Veldhuis, Sjoerd A. ;
Brinks, Peter ;
ten Elshof, Johan E. .
THIN SOLID FILMS, 2015, 589 :503-507
[37]   Influence of target-substrate distance and composition on the preferential orientation of yttria-stabilized zirconia thin films [J].
Lamas, J. S. ;
Leroy, W. P. ;
Depla, D. .
THIN SOLID FILMS, 2012, 520 (14) :4782-4785
[38]   ANNIHILATION OF PARAMAGNETIC CENTERS IN YTTRIA-STABILIZED ZIRCONIA [J].
AZZONI, CB ;
PALEARI, A .
SOLID STATE IONICS, 1991, 46 (3-4) :259-263
[39]   Dielectric Relaxation in Yttria-stabilized Zirconia Crystals [J].
Wang, Wencheng ;
Zhang, Peng ;
Li, Xiufeng ;
Li, Ping'an ;
Zhang, Hao ;
Zhan, Lijuan .
PROCEEDINGS OF 2020 INTERNATIONAL SYMPOSIUM ON ELECTRICAL INSULATING MATERIALS (ISEIM 2020), 2020, :210-212
[40]   Sputter-deposited 20 mol% gadolinia-doped ceria films on 8 mol% yttria-stabilized zirconia tapes for improved electrochemical performance [J].
Kuo, Yu-Lin ;
Lin, Sung-En ;
Wei, Wen-Cheng J. ;
Su, Yu-Ming .
THIN SOLID FILMS, 2016, 618 :202-206