Optimization of thick rubber part curing cycles

被引：11

作者：

El Labban, A. ^{[2
]}

Mousseau, P. ^{[1
]}

Bailleul, J. L. ^{[3
]}

Deterre, R. ^{[1
]}

机构：

[1] OPERP GEPEA ERT 1086, Nantes, France

[2] LRCCP, Vitry Sur Seine, France

[3] Ecole Polytech Nantes, LTN UMR CNRS 6607, Nantes, France

来源：

INVERSE PROBLEMS IN SCIENCE AND ENGINEERING | 2010年 / 18卷 / 03期

关键词：

optimization; adjoin problem; moulding; rubber; curing; heat transfer; VULCANIZATION;

D O I：

10.1080/17415971003589517

中图分类号：

T [工业技术];

学科分类号：

08 ;

摘要：

Thick rubber part moulding is a process, during which coupling between heat and chemical kinetic equations is strong. Automatic tooling control, therefore, is the guarantee of achieving proper curing within the mould. This article initially presents a detailed method for curing optimization. With this aim in view, the optimum temperature cycle for the desired curing state is examined. The use, here, of the conjugate gradient method implies to determine the solution of both adjoin and sensitivity equations. A sensitivity study is also conducted in order to improve the kinetic model. Finally, some optimization examples are discussed.

引用

页码：313 / 340

页数：28

共 9 条

[1]

BAILLEUL JL, 1994, P 10 INT HEAT TRANSF, P203

[2]

BAILLEUL JL, 1998, 11 INT HEAT TEMP C 2, V5, P87

[3]

Beck J.V., 1985, Inverse Heat Conduction: Ill-Posed Problems

[4] Temperature measurement and control within moulded rubber during vulcanization process [J].