Novel two-step CdS deposition strategy to improve the performance of Cu2ZnSn(S,Se)4 solar cell

被引:8
作者
Teng, Lifang [1 ,2 ]
Tong, Junye [1 ,2 ,3 ]
Wang, Gang [3 ]
Wang, Lingling [1 ,2 ]
Chen, Liping [1 ,2 ]
Wang, Shaotong [1 ,2 ]
Wang, Yinglin [1 ,2 ]
Pan, Daocheng [3 ]
Zhang, Xintong [1 ,2 ]
Liu, Yichun [1 ,2 ]
机构
[1] Northeast Normal Univ, Ctr Adv Optoelect Funct Mat Res, Changchun 130024, Jilin, Peoples R China
[2] Northeast Normal Univ, Key Lab UV Emitting Mat & Technol, Minist Educ, Changchun 130024, Jilin, Peoples R China
[3] Chinese Acad Sci, Changchun Inst Appl Chem, State Key Lab Rare Earth Resource Utilizat, Changchun 130022, Jilin, Peoples R China
来源
JOURNAL OF ENERGY CHEMISTRY | 2020年 / 42卷
基金
中国国家自然科学基金;
关键词
Solar cell; CdS; Two-step deposition; Heterojunction interface; BAND ALIGNMENT; THIN-FILMS; CU2ZNSNS4; EFFICIENCY; SELENIZATION; TEMPERATURE; FABRICATION; DEFECTS; IMPACT; DEVICE;
D O I
10.1016/j.jechem.2019.06.011
中图分类号
O69 [应用化学];
学科分类号
081704 ;
摘要
Kesterite Cu2ZnSn(S,Se)(4) (CZTSSe) solar cells have drawn worldwide attention for their promising photo-voltaics performance and earth-abundant element composition, yet the record efficiency of this type of device is still far lower than its theoretical conversion efficiency. Undesirable band alignment and severe non-radiative recombination at CZTSSe/CdS heterojunction interfaces are the major causes limiting the current/voltage output and overall device performance. Herein, we propose a novel two-step CdS deposition strategy to improve the quality of CZTSSe/CdS heterojunction interface and thereby improve the performance of CZTSSe solar cell. The two-step strategy includes firstly pre-deposits CdS thin layer on CZTSSe absorber layer by chemical bath deposition (CBD), followed with a mild heat treatment to facilitate element inter-diffusion, and secondly deposits an appropriate thickness of CdS layer by CBD to cover the whole surface of pre-deposited CdS and CZTSSe layers. The solar energy conversion efficiency of CZTSSe solar cells with two-step deposited CdS layer approaches to 8.76% (with an active area of about 0.19 cm(2)), which shows an encouraging improvement of over 87.98% or 30.16% compared to the devices with traditional CBD-deposited CdS layer without and with the mild annealing process, respectively. The performance enhancement by the two-step CdS deposition is attributed to the formation of more favorable band alignment at CZTSSe/CdS interface as well as the effective decrease in interfacial recombination paths on the basis of material and device characterizations. The two-step CdS deposition strategy is simple but effective, and should have large room to improve the quality of CZTSSe/CdS heterojunction interface and further lift up the conversion efficiency of CZTSSe solar cells. (C) 2019 Science Press and Dalian Institute of Chemical Physics, Chinese Academy of Sciences. Published by Elsevier B.V. and Science Press. All rights reserved.
引用
收藏
页码:77 / 82
页数:6
相关论文
共 36 条
  • [1] Classification of Lattice Defects in the Kesterite Cu2ZnSnS4 and Cu2ZnSnSe4 Earth-Abundant Solar Cell Absorbers
    Chen, Shiyou
    Walsh, Aron
    Gong, Xin-Gao
    Wei, Su-Huai
    [J]. ADVANCED MATERIALS, 2013, 25 (11) : 1522 - 1539
  • [2] Microstructure Evolution During Selenization of Cu2ZnSnS4 Colloidal Nanocrystal Coatings
    Chernomordik, Boris D.
    Ketkar, Priyanka M.
    Hunter, Anne K.
    Beland, Amelie E.
    Deng, Donna D.
    Aydil, Eray S.
    [J]. CHEMISTRY OF MATERIALS, 2016, 28 (05) : 1266 - 1276
  • [3] Large process-dependent variations in band alignment and interface band gaps of Cu2ZnSnS4/CdS solar cells
    Crovetto, Andrea
    Cazzaniga, Andrea
    Ettlinger, Rebecca Bolt
    Schou, Jorgen
    Hansen, Ole
    [J]. SOLAR ENERGY MATERIALS AND SOLAR CELLS, 2018, 187 : 233 - 240
  • [4] What is the band alignment of Cu2ZnSn(S,Se)4 solar cells?
    Crovetto, Andrea
    Hansen, Ole
    [J]. SOLAR ENERGY MATERIALS AND SOLAR CELLS, 2017, 169 : 177 - 194
  • [5] Raman scattering quantitative analysis of the anion chemical composition in kesterite Cu2ZnSn(SxSe1-x)4 solid solutions
    Dimitrievska, Mirjana
    Gurieva, Galina
    Xie, Haibing
    Carrete, Alex
    Cabot, Andreu
    Saucedo, Edgardo
    Perez-Rodriguez, Alejandro
    Schorr, Susan
    Izquierdo-Roca, Victor
    [J]. JOURNAL OF ALLOYS AND COMPOUNDS, 2015, 628 : 464 - 470
  • [6] How small amounts of Ge modify the formation pathways and crystallization of kesterites
    Giraldo, S.
    Saucedo, E.
    Neuschitzer, M.
    Oliva, F.
    Placidi, M.
    Alcobe, X.
    Izquierdo-Roca, V.
    Kim, S.
    Tampo, H.
    Shibata, H.
    Perez-Rodriguez, A.
    Pistor, P.
    [J]. ENERGY & ENVIRONMENTAL SCIENCE, 2018, 11 (03) : 582 - 593
  • [7] Structural characterization of off-stoichiometric kesterite-type Cu2ZnGeSe4 compound semiconductors: from cation distribution to intrinsic point defect density
    Gunder, R.
    Marquez-Prieto, J. A.
    Gurieva, G.
    Unold, T.
    Schorr, S.
    [J]. CRYSTENGCOMM, 2018, 20 (11): : 1491 - 1498
  • [8] Significantly Enhancing Grain Growth in Cu2ZnSn(S,Se)4 Absorber Layers by Insetting Sb2S3, CuSbS2, and NaSb5S8 Thin Films
    Guo, Hongling
    Cui, Yong
    Tian, Qingwen
    Gao, Shang
    Wang, Gang
    Pan, Daocheng
    [J]. CRYSTAL GROWTH & DESIGN, 2015, 15 (02) : 771 - 777
  • [9] Enhancing the performance of CZTSSe solar cells with Ge alloying
    Guo, Qijie
    Ford, Grayson M.
    Yang, Wei-Chang
    Hages, Charles J.
    Hillhouse, Hugh W.
    Agrawal, Rakesh
    [J]. SOLAR ENERGY MATERIALS AND SOLAR CELLS, 2012, 105 : 132 - 136
  • [10] Impact of annealing treatment before buffer layer deposition on Cu2ZnSn(S, Se)4 solar cells
    Hironiwa, Daisuke
    Sakai, Noriyuki
    Kato, Takuya
    Sugimoto, Hiroki
    Tang, Zeguo
    Chantana, Jakapan
    Minemoto, Takashi
    [J]. THIN SOLID FILMS, 2015, 582 : 151 - 153