Research on durability of turning tools made of low-alloy high-speed steels

被引：24

作者：

Jaworski, J. ^{[1
]}

Trzepiecinski, T. ^{[1
]}

机构：

[1] Rzeszow Univ Technol, Fac Mech Engn & Aeronaut, Al Powstancow Warszawy 12, PL-35959 Rzeszow, Poland

来源：

KOVOVE MATERIALY-METALLIC MATERIALS | 2016年 / 54卷 / 01期

关键词：

deformation; high temperature; powder processing; steels; wear; WEAR; FORCES;

D O I：

10.4149/km_2016_1_17

中图分类号：

T [工业技术];

学科分类号：

08 ;

摘要：

This paper presents the results of investigations of temperature field distribution in the cutting edge and yield strength of tool material for low-alloy high-speed steels. Investigations of temperature distribution in cutting edges were made during C60 steel turning using a semi-natural constantan thermo-element. The obtained results show that the decrease in addition alloy content does not influence the change in thermal-physical properties of low alloy high-speed steels. Investigations of the durability of cutting edges confirm that to define working conditions of the tool made of high-speed steel, resistance against hardness loss with increasing temperature at temperatures higher and lower than tempering temperature is the most significant. The results of durability investigations of cutters made of HS3-1-2 steel with various kinds of surface treatment confirm the reasons for cutting edge wear of tools made of high-speed steel and ways of the increasing their durability.

引用

页码：17 / 25

页数：9

共 31 条

[1]

Abhang L.B., 2010, INT J ENG SCI TECHNO, V2, P382

[2] The microstructure changes in high-speed steels during continuous heating from the as-quenched state [J].