Study of the interlayer adhesion and warping during material extrusion-based additive manufacturing of a carbon nanotube/biobased thermoplastic polyurethane nanocomposite

被引：22

作者：

Candal, Maria Virginia ^{[1
,2
,3
]}

Calafel, Itxaso ^{[2
,3
]}

Fernandez, Mercedes ^{[2
,3
]}

Aranburu, Nora ^{[2
,3
]}

Aguirresarobe, Roberto Hernandez ^{[2
,3
]}

Gerrica-Echevarria, Gonzalo ^{[2
,3
]}

Santamaria, Antxon ^{[2
,3
]}

Muller, Alejandro J. ^{[2
,3
,4
]}

机构：

[1] Univ Simon Bolivar, Dept Mecan, Grp Polimeros, Apartado,89000, Caracas 1080A, Venezuela

[2] Univ Basque Country UPV EHU, POLYMAT, Paseo Manuel Lardizabal,3, Donostia San Sebastian 20018, Spain

[3] Univ Basque Country UPV EHU, Fac Chem, Paseo Manuel Lardizabal,3, Donostia San Sebastian 20018, Spain

[4] Ikerbasque, Basque Fdn Sci, Bilbao, Spain

来源：

POLYMER | 2021年 / 224卷

基金：

欧盟地平线“2020”;

关键词：

Thermoplastic polyurethane; Biobased TPU; Carbon nanotubes; Material extrusion-based additive; manufacturing; Entanglements; Inter-diffusion; FILAMENT-FABRICATION METHOD; POLYMER; BEHAVIOR; OPTIMIZATION; SURFACES; QUALITY;

D O I：

10.1016/j.polymer.2021.123734

中图分类号：

O63 [高分子化学（高聚物）];

学科分类号：

070305 ; 080501 ; 081704 ;

摘要：

A thermoplastic bio-polyurethane from renewable sources (TPU) and the nanocomposite developed by mixing it with carbon nanotubes (CNT) are investigated as potentially adequate for Material Extrusion-based Additive Manufacturing (EAM). Thermal and rheological features are studied from the perspective of their liaisons with printing adequacy and conditions. As predicted by rheology, both samples show good performance in filament elaboration and flow in the nozzle. Warpage is observed for TPU, but not for the nanocomposite, which is due to the effect of CNT nanoparticles on polymer chains dynamics. At the studied printing velocities, interlayer adhesion strength is independent of printing velocity implying that there is no significant chain orientation which can induce changes in the TPU entanglements. The nanocomposite shows a lower welding strength, notwithstanding both have the same chain entanglements density. This is explained by considering that the higher viscosity of TPU/CNT, as compared to TPU, reduces the melt diffusion coefficient.

引用

页数：9

共 45 条

[1] Layered manufacturing of surfaces with open contours using localized wall thickening [J].