Improving the stability of CdS quantum dot sensitized solar cell using highly efficient and porous CuS counter electrode

Thin films from copper sulfide (CuxS) are the most commonly used electrocatalyst counter electrodes (CEs) for high-efficiency quantum dot sensitized solar cells (QDSSCs) because of its superior electrocatalytic activity in the presence of polysulfide electrolytes. In addition to the stability issues, the CuxS CEs are usually prepared by complicated, costly, time consuming, and less productive methods, which are inadequate for practical applications of QDSSCs. In this work, we present a simple approach for fabricating an efficient and stable CE for QDSSCs using pure covellite phase CuS nanoparticles (NPs) pre-prepared via a cheap, fast, and scalable chemical method. The catalyst ink was obtained by mixing the as-prepared CuS NPs with polyvinylidene fluoride, as a polymeric binder, which was then directly applied to a conductive fluorine-doped tin oxide substrate without any further high temperature post treatment. Cyclic voltammetry (CV), electrochemical impedance spectroscopy (EIS), and Tafel polarization measurements were used to investigate the electrocatalytic activity of the CuS NPs CE. The power conversion efficiency of 2.6% was achieved from CdS QDSSC assembled with CuS NPs CE, which was higher than 1.57% for conventional Cu2S/brass and 1.33% for Pt CEs under one-sun illumination. The CdS QDSSC with CuS NPs CE was also able to supply a constant photocurrent value without any obvious decrease under light soaking test, in contrast to the devices with Cu2S/brass and Pt CEs, which showed inferior stability. This remarkable photovoltaic performance was attributed to the nanoporous morphology and the excellent electrocatalytic activity of CuS NPs CE. Published by AIP Publishing.