In-situ synthesis of MgAl2O4 nanowhiskers reinforced 6061 aluminum alloy composites by reaction hot pressing

被引:19
作者
Xing, Li [1 ]
Zhang, Yaxuan [1 ]
Shi, Chunsheng [1 ]
Zhou, Yang [1 ]
Zhao, Naiqin [1 ]
Liu, Enzuo [1 ]
He, Chunnian [1 ]
机构
[1] Tianjin Univ, Sch Mat Sci & Engn, Tianjin Key Lab Composite & Funct Mat, Tianjin 300072, Peoples R China
来源
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING | 2014年 / 617卷
关键词
Mechanical characterization; Composites; Powder metallurgy; Sintering; MATRIX COMPOSITES; MECHANICAL-PROPERTIES; SPINEL; MICROSTRUCTURE; FABRICATION; BEHAVIOR; WHISKERS;
D O I
10.1016/j.msea.2014.08.066
中图分类号
TB3 [工程材料学];
学科分类号
0805 ; 080502 ;
摘要
In-situ generated MgAl2O4 nanowhiskers, with diameters ranging from 30 to 200 nm, reinforced 6061 aluminum alloy composites have been successfully synthesized by reaction hot pressing under a relatively low temperature (600 degrees C). The effects of temperature and pressure on the morphology of MgAl2O4 whiskers, as well as microstructure, densification and mechanical properties of the composites were investigated in detail. The results indicate that the MgAl2O4 nanowhiskers with aspect ratio about 10-50 are uniformly distributed and firmly bonded with the matrix. Most of the nanowhiskers acting as bridges penetrate into the Al particles to form a framework bearing and transferring extrinsic loads. The high-resolution transmission electron microscope observation reveals that the MgAl2O4/Al interface is clean, smooth and free from interfacial product, and the whiskers have well-bonded interfaces with matrix. Additionally, the composites, prepared by sintering at 600 degrees C under the pressure of 50 MPa, exhibit the optimal performance. (C) 2014 Elsevier B.V. All rights reserved.
引用
收藏
页码:235 / 242
页数:8
相关论文
共 28 条
  • [1] Young's modulus measurements of magnesia-spinel composites using load-deflection curves, sonic modulus, strain gauges and Rayleigh waves
    Aksel, C
    Riley, FL
    [J]. JOURNAL OF THE EUROPEAN CERAMIC SOCIETY, 2003, 23 (16) : 3089 - 3096
  • [2] Hardness of Multi Wall Carbon Nanotubes reinforced aluminium matrix composites
    Bradbury, Christopher R.
    Gomon, Jaana-Kateriina
    Kollo, Lauri
    Kwon, Hansang
    Leparoux, Marc
    [J]. JOURNAL OF ALLOYS AND COMPOUNDS, 2014, 585 : 362 - 367
  • [3] Low temperature hot-pressed BAS matrix composites reinforced with in situ grown Si3N4 whiskers
    Chen, S
    Ye, F
    Zhou, Y
    [J]. CERAMICS INTERNATIONAL, 2002, 28 (01) : 51 - 58
  • [4] The effect of sintering time on synthesis of in situ submicron α-Al2O3 particles by the exothermic reactions of CuO particles in molten pure Al
    Dikici, Burak
    Gavgali, Mehmet
    [J]. JOURNAL OF ALLOYS AND COMPOUNDS, 2013, 551 : 101 - 107
  • [5] Microstructure and mechanical properties of in situ TiB reinforced titanium matrix composites based on Ti-FeMo-B prepared by spark plasma sintering
    Feng, HB
    Zhou, Y
    Jia, DC
    Meng, QC
    [J]. COMPOSITES SCIENCE AND TECHNOLOGY, 2004, 64 (16) : 2495 - 2500
  • [6] Correlation between residual stresses and the strength differential effect in PM 6061Al-15 vol% SiCw composites:: experiments, models and predictions
    Fernández, R
    Bruno, G
    González-Doncel, G
    [J]. ACTA MATERIALIA, 2004, 52 (19) : 5471 - 5483
  • [7] Titanium matrix composites processed by continuous binder-powder coating: An alternative fabrication route
    Ferreira, R. A. Sanguinetti
    Arvieu, C.
    Guillaume, B.
    Quenisset, J. M.
    [J]. COMPOSITES PART A-APPLIED SCIENCE AND MANUFACTURING, 2006, 37 (10) : 1831 - 1836
  • [8] Influence of processing route on microstructure and mechanical properties of MgAl2O4 spinel
    Ganesh, Ibram
    Reddy, G. Jaganatha
    Sundararajan, G.
    Olhero, Susana M.
    Torres, Paula M. C.
    Ferreira, Jose M. F.
    [J]. CERAMICS INTERNATIONAL, 2010, 36 (02) : 473 - 482
  • [9] In situ preparation of titanium base composites reinforced by TiB single crystals using a powder metallurgy technique
    Gorsse, S
    Chaminade, JP
    Le Petitcorps, Y
    [J]. COMPOSITES PART A-APPLIED SCIENCE AND MANUFACTURING, 1998, 29 (9-10) : 1229 - 1234
  • [10] Microstructure and properties of tetrapod-like ZnO whiskers reinforced Al matrix composite
    Guo, Zhixing
    Xiong, Ji
    Yang, Mei
    Li, Wei
    [J]. JOURNAL OF ALLOYS AND COMPOUNDS, 2008, 461 (1-2) : 342 - 345