Influence of thermal expansion bend and tubesheet geometry on guided wave inspection of steam generator tubes of a fast breeder reactor

Periodic assessment of steam generator tubes of a sodium-cooled nuclear reactor is very crucial for smooth operation of steam generators. To examine the integrity, an in-bore magnetostrictive transducer capable of launching and receiving longitudinal ultrasonic guided waves (L(0,2) mode) from the inner diameter side of a steam generator tube developed in-house is used. Preliminary tests conducted on defective steam generator tubes with thermal expansion bends (three successive bends) of the mockup steam generator test facility yield a good sensitivity of 20% wall thickness deep flaw (0.46-mm deep and 1-mm wide half-circumferential groove) and the location accuracy of 10 mm. In order to remove high noise, wavelet-based denoising using discrete wavelet transform is used which improves the signal-to-noise ratio by 5-10 dB. In addition, cross-correlation technique is also used to denoise and unambiguously identify the defect echoes amid noise and multiple reflections between the defects. Furthermore, influence of the thermal expansion bend and tubesheet-spigot structure on L(0,2) mode is studied using the finite element analysis. It is observed that in the thermal expansion (multiple) bend, axisymmetric L(0,2) mode becomes non-axisymmetric (maximum and minimum amplitudes at extrados and intrados, respectively) and undergoes mode conversion to a weak flexural mode F(1,3). The results are validated experimentally. In the tubesheet-spigot structure, L(0,2) mode is found to have similar to 10% reflection from spigot-tubesheet transitions, and it is seen to mode convert to bulk waves in the tubesheet. In conclusion, thicker tubesheets are found to be better from the perspective of inspection.