Improvement in secondary cooling of continuous casting of round billets through analysis of heat flux distribution

被引：8
作者：
Assuncao, C. [1 ]
Tavares, R. [1 ]
Oliveira, G. [1 ]
机构：
[1] Univ Fed Minas Gerais, Dept Met & Mat Engn, Belo Horizonte, MG, Brazil
来源：
IRONMAKING & STEELMAKING | 2015年 / 42卷 / 01期
关键词：
Water flux distribution; Heat transfer coefficient; Secondary cooling; Round billet; Mathematical model; SOLIDIFICATION MODEL; STEEL; MOLD; ZONE; TEMPERATURE; CASTER;
D O I：
10.1179/1743281214Y.0000000190
中图分类号：
TF [冶金工业];
学科分类号：
0806 ;
摘要：
A mathematical model of heat transfer and solidification for a continuous casting of round billets was developed. The water flux density of the secondary cooling zone was experimentally measured, using an apparatus in industrial scale with two types of nozzles, flat jet and full cone jet. The profiles of water distribution were applied on the mathematical model. The results showed that the water distribution is not uniform in both longitudinal and angular directions owing to the unevenness of the spray and to the curvature effect of the round billet. This non-uniformity causes important variation of the heat transfer coefficients and superficial temperature of the billet, especially in the first cooling zones, where the temperature is higher. The mathematical model was used to simulate a change of nozzle type in the first cooling zone. The results showed that the heat flux and superficial temperature variations were reduced with a full cone jet nozzle in comparison with the flat jet nozzles.
引用
收藏
页码：1 / 8
页数：8
相关论文
共 30 条
  • [1] [Anonymous], 2007, P AISTECH STEELM C I
  • [2] Brimacombe J., 1976, CAN METALL Q, V15, P17
  • [3] Brimacombe J., 1984, CONTINUOUS CASTING, V2, P1
  • [4] Brimacombe J., 1984, CONTIN CAST, V1, P109
  • [5] Brimacombe J., 1984, CONTINUOUS CASTING H, V2, P215
  • [6] Brimacombe JK., 1984, CONTINUOUS CASTING, V2, P109
  • [7] Calzolari F., 1998, ISIJ INT, V38, P447
  • [8] MATHEMATICAL-MODELING OF HEAT-TRANSFER PHENOMENA IN CONTINUOUS-CASTING OF STEEL
    CHOUDHARY, SK
    MAZUMDAR, D
    GHOSH, A
    [J]. ISIJ INTERNATIONAL, 1993, 33 (07) : 764 - 774
  • [9] Flemings MC, 1974, Solidification processing
  • [10] Gilles H., 2003, MAKING SHAPING TREAT, V18, P1
123