The treatment of run-off from a fertiliser plant for nitrification, denitrification and phosphorus removal by use of constructed wetlands: a demonstration study

The paper describes an evaluation carried out on demonstration scale to show that it was possible to use a Hybrid Reed Bed System comprising a Horizontal flow and a Vertical Flow Bed for treating the high strength run-off from a fertiliser packaging plant. The site is located close to an estuary which is sensitive to nutrients. The environmental regulators were therefore concerned that excessive mass flows of nitrate, ammoniacal nitrogen and phosphate, potentially arising from the site run-off, were not discharged into the estuary. The fertiliser manufacturing company required a simple, low maintenance system for removing nitrogen and phosphorus. A series of experimental runs were carried out to characterise the performance of the Hybrid System, establishing the effluent quality that could be achieved and the mass removal rate which was appropriate for acceptable treatment. These tests showed that it was possible to achieve a reduction of 79% in Total N whilst using molasses as a carbon source for denitrification. When using a 4: 1 recycle ratio this produced an effluent with concentrations of 14 mg NH(4)-N/litre and 18 mg NO(3)-N/litre from treating site run-off containing concentrations in the order of 75 mg/litre of both NH(3)N and NO(3)-N. Chemical dosing with an iron salt brought the P concentration down to around 0.5 mg PO(4)-P/litre.