Dielectric properties of plasma-spray-deposited BaTiO3 and Ba0.68Sr0.32TiO3 thick films

被引:10
作者
Ahn, K [1 ]
Wessels, BW
Sampath, S
机构
[1] Northwestern Univ, Dept Mat Sci & Engn, Evanston, IL 60208 USA
[2] SUNY Stony Brook, Dept Mat Sci & Engn, Stony Brook, NY 11794 USA
基金
美国国家科学基金会;
关键词
D O I
10.1557/JMR.2003.0168
中图分类号
T [工业技术];
学科分类号
08 ;
摘要
The dielectric properties of high-k dielectric BaTiO3 and Ba0.68Sr0.32TiO3 thick films deposited on alumina substrates using a plasma-spray process were investigated. The as-deposited films were predominantly crystalline but contained an amorphous second phase, the amount of which depended on spray conditions. The effect of the spray conditions on crystallinity was studied and related to the dielectric properties of the films. The presence of a low dielectric constant interfacial layer in plasma-spray-deposited films was determined from the dependence of the dielectric constant on film thickness. After annealing at 500 degreesC for 20 h in air, the crystallinity and dielectric constant increased. Annealing was-also found to affect the interfacial layer properties.
引用
收藏
页码:1227 / 1231
页数:5
相关论文
共 13 条
[1]  
AHN K, 2002, MAT RES SOC S P, V698
[2]   INVESTIGATION OF THE FORMATION OF AN AMORPHOUS FILM AT THE ZRO2-Y2O3/NICOCRALY INTERFACE OF THERMAL BARRIER COATINGS PRODUCED BY PLASMA SPRAYING [J].
BARTULI, C ;
BERTAMINI, L ;
MATERA, S ;
STURLESE, S .
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING, 1995, 199 (02) :229-237
[3]   Commercial applications and review for direct write technologies [J].
Church, KH ;
Fore, C ;
Feeley, T .
MATERIALS DEVELOPMENT FOR DIRECT WRITE TECHNOLOGIES, 2000, 624 :3-8
[4]   Dielectric properties of plasma sprayed titanates [J].
Ctibor, P ;
Sedlacek, J .
JOURNAL OF THE EUROPEAN CERAMIC SOCIETY, 2001, 21 (10-11) :1685-1688
[5]   High velocity oxy-fuel and plasma deposition of BaTiO3 and (Ba,Sr)TiO3 [J].
Dent, AH ;
Patel, A ;
Gutleber, J ;
Tormey, E ;
Sampath, S ;
Herman, H .
MATERIALS SCIENCE AND ENGINEERING B-SOLID STATE MATERIALS FOR ADVANCED TECHNOLOGY, 2001, 87 (01) :23-30
[6]  
DESU SB, 1990, MATER RES SOC SYMP P, V200, P199, DOI 10.1557/PROC-200-199
[7]  
Heywang W., 1954, Physics, V6, P385
[8]  
KINGERY WD, 1976, INTRO CERAMICS, P947
[9]   Intrinsic residual stresses in single splats produced by thermal spray processes [J].
Matejicek, J ;
Sampath, S .
ACTA MATERIALIA, 2001, 49 (11) :1993-1999
[10]   Thermal spray techniques for fabrication of meso-electronics and sensors [J].
Sampath, S ;
Herman, H ;
Patel, A ;
Gambino, R ;
Greenlaw, R ;
Tormey, E .
MATERIALS DEVELOPMENT FOR DIRECT WRITE TECHNOLOGIES, 2000, 624 :181-188