A 3.2-V operation single-chip dual-band AlGaAs/GaAs HBT MMIC power amplifier with active feedback circuit technique

This paper describes the design and experimental results for a 3.2-V operation single-chip AlGaAs/GaAs heterojunction bipolar transistor (HBT) monolithic microwave integrated circuit (MMIC) power amplifier for GSM900 and DCS1800 dual-band applications. The following two new circuit techniques are proposed for implementing the power amplifier. One is an on-chip HBT bias switch which in turn switches the amplifier between 900 and 1800 MHz, The proposed switch configuration allows the switch using a high turn-on voltage of 1.3 V of AlGaAs/GaAs HBT's to operate with a 3-V low supply voltage, because the switch circuitry needs no stacked configuration. The other is an active feedback circuit (AFB) to prevent permanent failure of HBT's in the output power stage even under severe conditions of oversupply voltage and strongly mismatching load. Experimental results revealed that the proposed feedback circuit, which works as a voltage limiter, can protect the output stage HBT's from an excessive collector voltage swing even when the amplifier is operated under a condition of a 5-V oversupply voltage and a 10:1 voltage standing-wave ratio (VSWR) mismatching load. Under a normal condition of 3.2 V and a 50-Omega matching load, the IC is capable of delivering an output power of 34.5 dBm and a power-added efficiency (PAE) of 52% in a GSM900 mode, and a 32-dBm output power and a 42% PAE in a DCS1800 mode.