Construction of Buertai Coal Macromolecular Model and GCMC Simulation of Methane Adsorption in Micropores

With the increase in high gas mines in the low coal rank mining area in the northwestern part of China, high gas mines in the low-rank coal mining area have caused many gas emission accidents. Coal is a porous material, containing a large number of micropores (<2 nm), which can absorb large amounts of methane, so it is necessary to explore methane adsorption in micropores of low-rank coal. In this work, FTIR, HRTEM, and 13C-NMR were used to test the macromolecular structural parameters of Buertai coal, which was a kind of low-rank Jurassic coal in northwestern China. The results showed that the aromatic structural units in the Buertai coal structure mainly consist of naphthalene, anthracene, and phenanthrene. The fat structure mainly occurs in the form of aliphatic side chains, cycloalkanes, and other compounds. The oxygen atoms are present in the form of carbonyl groups, ether bonds, and phenol groups with a ratio of about 6:4:9. The nitrogen atoms are present in the form of pyrrole and pyridine compounds. Finally, the macromolecular structure model of Buertai coal was built, and the calculated NMR spectrum from the model was very consistent with the experimental NMR spectrum of Buertai coal. The relationship between the macromolecular density and energy of Buertai coal was explored using the Amorphous Cell module in the simulation software, Materials Studios 8.0 (MS 8.0), and the density value at the lowest energy was determined to be about 1.23 g/cm(3). The pore structure parameters of Buertai coal were also calculated. It was found that both pore volume and void fraction decreased evenly as the diameter of the probe molecule increased, but the surface area decreased rapidly when the diameter of the probe molecule was 3.46 A. All pore sizes were found to be smaller than 10 A from the pore size distribution (PSD) curve of Buertai coal, which provided a lot of adsorption sites for methane (CH4). The results of the CH4 adsorption simulation from Grand Canonical Monte Carlo (GCMC) showed that CH4 is adsorbed inside the micropores of coal, and the adsorption capacity of CH4 depends on the diameters of micropores when the micropores are less than 8.5 A. There are many micropores where CH4 did not appear because these micropores are closed and did not provide a channel for CH4 to enter. The results of experimental methane adsorption indicate that the excess adsorption capacity from the GCMC simulation was very close to the experimental results of Buertai coal. This work provides a new perspective to study the methane adsorption behavior in micropores of coal.