Numerical simulation of deuterium-tritium fusion reaction rate in laser plasma based on Monte Carlo-discrete ordinate method

Inertial confinement fusion (ICF) is one of the possible ways to realize controlled thermonuclear fusion. The fusion neutron source term is one of the important parameters in the physical design and analysis of laser plasma. The accuracy of the fusion neutron source term directly affects the reliability of the analysis results. At present, the neutron source term of deuterium-tritium fusion reaction in ICF is mainly based on formula method. It has limited applications in temperature and reaction type. Because of a large quantity of data, it is impossible to simulate the fusion reaction of each particle. In this paper, the concept of particle cloud is introduced, that is, the collection of the like particles with the same position and speed, and it is considered that the action of particle cloud is the same reaction. Because the particles should satisfy the Maxwell velocity distribution at a certain temperature and the direction is all around the circumference angle, the collision cross sections between the incident particle and different target particles are different. Therefore, the design program takes all the possible velocities, polar angles and direction angles, reads the collision cross sections between deuterium and tritium and makes corrections, and obtains the multi-temperature differential correction cross sections of deuterium and tritium fusion with Doppler energy broadening. On these bases, Monte Carlo method and discrete ordinate method method are used. A numerical simulation program for the fusion rate of D-T particles in laser plasma is developed in this paper. It is found that there are significant differences between the DT, DD, TD cross sections and the original cross sections after Doppler broadening. In a range of plasma temperature between 20 keV and 100 keV, the simulation results are more consistent with the cross section data of ENDF/B-VI and ENDF/B-VII databases of deuterium-tritium fusion reaction than those from the analytical formula method. There is a large error between the numerical simulation results and the analytical formula method in the low energy region. It may be caused by the difference of calculation methods and too big difference among the used fusion cross sections at low temperature.