Mechanical and tribological properties of boron, nitrogen-coincorporated diamond-like carbon films prepared by reactive radio-frequency magnetron sputtering

We have deposited boron- and/or nitrogen-incorporated DLC films by radio-frequency magnetron sputtering, and systematically investigated the structure and the mechanical and tribological properties. The N content in DLC films increased with increasing N-2 flow ratio [N-2/(Ar + N-2)], and it tended to be saturated at higher N-2 flow ratios. The N content further increased with an increase in the B content of the targets. The B/C ratios of the films were almost the same as those of the B-containing targets regardless of the N content. Scratch tests revealed that the adhesion strength of N-incorporated DLC films decreased with increasing N-2 flow ratio and the critical loads of B-incorporated films were lower than that of an unincorporated film. It was found that for B. N-coincorporated films there was an optimum N-2 flow ratio at which the critical load became a maximum value, which was higher than that of the unincorporated film. The optimum N-2 flow ratio increased with an increase in the B composition of the targets. The N-incorporated films peeled off during ball-on-plate friction tests. On the other hand, the B, N-coincorporated films showed good wear-resistant properties that the specific wear rates were lower than those of the unincorporated and B-incorporated films. (C) 2010 Elsevier B.V. All rights reserved.