Preparation and performance study of solar pavement panel based on transparent Resin-Concrete

被引:18
作者
Hu, Hengwu [1 ]
Zha, Xudong [1 ]
Li, Zihao [1 ]
Lv, Ruidong [1 ]
机构
[1] Changsha Univ Sci & Technol, Sch Traff & Transportat Engn, Changsha 410114, Peoples R China
基金
中国国家自然科学基金;
关键词
Solar energy harvesting; Transparent resin-concrete; Solar pavement; Mix ratio; Pavement performance; Power generation efficiency; ENERGY; ROAD; TECHNOLOGIES;
D O I
10.1016/j.seta.2022.102169
中图分类号
X [环境科学、安全科学];
学科分类号
08 ; 0830 ;
摘要
In order to realize the transformation and utilization of renewable energy, a new solar pavement module, which can harvest solar energy using often uncovered pavement/road surfaces, is proposed and investigated in this paper. The module consists of a protective layer made of transparent resin-concrete and a built-in solar panel. The effect of different gradations and resin quantities (five gradation type of the glass aggregate, three kinds of resin content) on the optical properties, volume index, and mechanical properties are studied, and the pavement performance. Then a prototype of the module is built according to the optimized mix ratio. The pavement performance and photoelectric performance of solar pavement module were tested. Finally, the glare perfor-mance, sustainability of the transparency was conducted, and the economic-environment benefits were evalu-ated. The observed results of mix ratio design of optimal show that both the gradation type of the glass aggregate and the resin quantity have a significant impact on the optical properties and the mechanical properties but little effect on the volume index. Both the optical properties and compressive strength of the transparent resin-concrete improve with increasing resin fraction, while its density and void-ratio degrade. Considering mate-rial properties and cost, the optimal resin content is 43.7%. It was proved that solar pavement module had excellent high-temperature stability, low-temperature crack resistance, good water stability, good imperme-ability, and good skid resistance. The daily power generation of the solar pavement panel module is 0.152 kWh/m(2), which is about 16.28% of the original solar panel. The surface glare of transparent resin-concrete is 1.3 similar to 1.5 and 1.7 similar to 5.9 times than that of concrete and asphalt pavements, respectively, and the light-transmission de-creases with increasing surface pollutants. The LCOE of transparent resin-concrete solar pavement is 0.175 $/kWh, and can bring considerable economic, and emission reduction benefits.
引用
收藏
页数:12
相关论文
共 50 条
  • [41] Performance study of a sustainable solar heating system based on a copper coil water to air heat exchanger for greenhouse heating
    Ihoume, I.
    Tadili, R.
    Arbaoui, N.
    Bazgaou, A.
    Idrissi, A.
    Benchrifa, M.
    Fatnassi, H.
    [J]. SOLAR ENERGY, 2022, 232 : 128 - 138
  • [42] Preparation and Performance Study of SiC-Reinforced Fe-Based Wear-Resistant Composite Grinding Media
    Yang, Kun
    Zhou, Yongmin
    [J]. MATERIALS, 2024, 17 (12)
  • [43] Design and study of novel benzodithiazole-based hole transport materials for improved performance of perovskite solar cells: A DFT approach
    Mukhtar, Umar
    Anwar, Hafeez
    Jamil, Yasir
    Iqbal, Javed
    [J]. COLLOIDS AND SURFACES A-PHYSICOCHEMICAL AND ENGINEERING ASPECTS, 2024, 702
  • [44] An experimental study on the performance of single slope solar still integrated with a PCM-based pin-finned heat sink
    Yousef, Mohamed S.
    Hassan, Hamdy
    Kodama, S.
    Sekiguchi, H.
    [J]. 5TH INTERNATIONAL CONFERENCE ON POWER AND ENERGY SYSTEMS ENGINEERING (CPESE 2018), 2019, 156 : 100 - 104
  • [45] Experimental study on the thermal performance and pressure drop of a solar air collector based on flat micro-heat pipe arrays
    Zhu, Ting-ting
    Diao, Yan-hua
    Zhao, Yao-hua
    Deng, Yue-chao
    [J]. ENERGY CONVERSION AND MANAGEMENT, 2015, 94 : 447 - 457
  • [46] Adaptive neuro-fuzzy inference system modeling to predict the performance of graphene nanoplatelets nanofluid-based direct absorption solar collector based on experimental study
    Vakili, Masoud
    Yahyaei, Masood
    Ramsay, James
    Aghajannezhad, Pouria
    Paknezhad, Behnaz
    [J]. RENEWABLE ENERGY, 2021, 163 : 807 - 824
  • [47] Seismic Resilience Study of Piers Enhanced by Ultrahigh-Performance Concrete Jackets Based on Cyclic Loading Test and Static Push-Over Curves
    Zhang, Jianwei
    Li, Zhengfa
    Wang, Fan
    Zhuo, Saiyang
    Wang, Tao
    [J]. SCIENCE OF ADVANCED MATERIALS, 2022, 14 (11) : 1679 - 1691
  • [48] Performance assessment and multi-objective optimization of a multi-generation system based on solar tower power: A case study in Dubai, UAE
    Nedaei, Navid
    Azizi, Saeid
    Farshi, Leili Garousi
    [J]. PROCESS SAFETY AND ENVIRONMENTAL PROTECTION, 2022, 161 : 295 - 315
  • [49] Study on the effect of wind direction on the thermal performance of cavity receiver for trough solar system: Artificial neural network approach based on genetic algorithm
    Wang, Zhimin
    Kong, Fance
    Chan, Wenwu
    Yue, Shangyu
    [J]. ENERGY, 2025, 320
  • [50] Solar assisted heat pump system for multifamily buildings: Towards a seasonal performance factor of 5? Numerical sensitivity analysis based on a monitored case study
    Fraga, Carolina
    Hollmuller, Pierre
    Mermoud, Floriane
    Lachal, Bernard
    [J]. SOLAR ENERGY, 2017, 146 : 543 - 564