Experimental Study of the Effect of Air Filter Pressure Drop on Internal Combustion Engine Performance

被引:21
作者
Dziubak, Tadeusz [1 ]
Karczewski, Miroslaw [1 ]
机构
[1] Mil Univ Technol, Fac Mech Engn, 2 Gen Sylwestra Kaliskiego St, PL-00908 Warsaw, Poland
关键词
internal combustion engines; air filter pressure drop; engine power; hourly and specific fuel consumption; smoke opacity; PLEAT GEOMETRY; INTAKE SYSTEM; FUEL-ECONOMY; COMPONENTS; EMISSIONS; LOSSES; MODEL;
D O I
10.3390/en15093285
中图分类号
TE [石油、天然气工业]; TK [能源与动力工程];
学科分类号
0807 ; 0820 ;
摘要
The paper presents the problem of the effect of air filter pressure drop on the operating parameters of a modern internal combustion engine with compression ignition. A literature analysis of the results of investigations of the effect of air filter pressure drop on the filling, power and fuel consumption of carburetor and diesel engines with classical injection system was carried out. It was shown that each increase in the air filter pressure drop Delta p(f) by 1 kPa results in an average decrease in engine power by SI 1-1.5% and an increase in specific fuel consumption by about 0.7. For compression ignition engines, the values are 0.4-0.6% decrease in power and 0.3-0.5% increase in specific fuel consumption. The values of the permissible resistance of the air filter flow Delta p(fdop) determined from the condition of 3% decrease in engine power are given, which are at the level of 2.5-4.0 kPa-passenger car engines, 4-7 kPa-truck engines and 9-12 kPa-special purpose vehicles. Possibilities of decreasing the pressure drop of the inlet system, which result in the increase of the engine filling and power, were analyzed. The program and conditions of dynamometer engine tests were worked out in respect to the influence of the air filter pressure drop on the operation parameters of the six-cylinder engine of the swept volume V-ss = 15.8 dm(3) and power rating of 226 kW. Three technical states of the air filter were modeled by increasing the pressure drop of the filter element. For each technical state of the air filter, measurements and calculations of engine operating parameters, including power, hourly and specific fuel consumption, boost pressure and temperature, were carried out in the speed range n = 1000-2100 rpm. It was shown that the increase in air filter pressure drop causes a decrease in power (9.31%), hourly fuel consumption (7.87%), exhaust temperature (5.1%) and boost pressure (3.11%). At the same time, there is an increase in specific fuel consumption (2.52%) and the smoke of exhaust gases, which does not exceed the permissible values resulting from the technical conditions for admission of vehicles to traffic.
引用
收藏
页数:32
相关论文
共 74 条
[1]   Experimental and Numerical Analysis of a Motorcycle Air Intake System Aerodynamics and Performance [J].
Abd Halim, M. A. ;
Mohd, N. A. R. Nik ;
Nasir, M. N. Mohd ;
Dahalan, M. N. .
INTERNATIONAL JOURNAL OF AUTOMOTIVE AND MECHANICAL ENGINEERING, 2020, 17 (01) :7607-7617
[2]   Effects of Air Intake Pressure to the Fuel Economy and Exhaust Emissions on a Small SI Engine [J].
Abdullah, Nik Rosli ;
Shahruddin, Nafis Syabil ;
Mamat, Aman Mohd Ihsan ;
Kasolang, Salmiah ;
Zulkifli, Aminuddin ;
Mamat, Rizalman .
INTERNATIONAL TRIBOLOGY CONFERENCE MALAYSIA 2013, 2013, 68 :278-284
[3]   Parametric study on vehicle fuel economy and optimization criteria of the pleated air filter designs to improve the performance of an I.C diesel engine: Experimental and CFD approaches [J].
Allam, Sabry ;
Elsaid, Ashraf Mimi .
SEPARATION AND PURIFICATION TECHNOLOGY, 2020, 241
[4]  
Alves L.O.F.T., 2018, Technical Paper, DOI [10.4271/2017-36-0172, DOI 10.4271/2017-36-0172]
[5]  
[Anonymous], Rozporzdzenie Ministra Klimatu i rodowiska z dnia 7 wrzenia 2021 r. w sprawie wymaga w zakresie prowadzenia pomiarw wielkoci emisji, Regulation of the Minister of Climate and Environment, dated September 7, 2021
[6]  
[Anonymous], 2009, 155502009 PNISO
[7]  
Aradhye O, 2018, PROCEEDINGS OF THE ASME INTERNATIONAL MECHANICAL ENGINEERING CONGRESS AND EXPOSITION, 2017 VOL 6
[8]  
Barris M.A., 2018, SAE TECHNICAL PAPER
[9]  
Bernhard M., 1988, SILNIKI SAMOCHODOWE
[10]  
Bojdo N., 2014, P 40 EUROPEAN ROTORC