Analytical and experimental investigations of crack propagation in adhesively bonded joints with the Mixed Mode Bending (MMB) test Part II: Investigation of cohesive stresses distribution with backface strain monitoring

被引：8

作者：

Ben Salem, N. ^{[1
,2
,3
,4
]}

Jumel, J. ^{[1
,2
,3
]}

Budzik, M. K. ^{[1
,2
,3
,4
]}

Shanahan, M. E. R. ^{[1
,2
,3
]}

Lavelle, F. ^{[4
]}

机构：

[1] Univ Bordeaux, I2M, UMR 5295, F-33400 Talence, France

[2] CNRS, I2M, UMR 5295, F-33400 Talence, France

[3] CNRS, I2M, Arts & Met ParisTech, F-33400 Talence, France

[4] French Space Agcy CNES DLA, F-75612 Paris, France

来源：

THEORETICAL AND APPLIED FRACTURE MECHANICS | 2014年 / 74卷

关键词：

Bonded joint; Mixed mode bending test; Crack propagation; Cohesive stress; Backface strain monitoring; END NOTCHED FLEXURE; PROCESS ZONE; CANTILEVER BEAM; DELAMINATION; FRACTURE; FAILURE; LAWS; SIMULATION; TOUGHNESS; STRENGTH;

D O I：

10.1016/j.tafmec.2014.05.007

中图分类号：

TH [机械、仪表工业];

学科分类号：

0802 ;

摘要：

Backface strain monitoring is used for probing the peel and shear cohesive stresses distribution along an adhesive layer during a crack propagation test under mixed mode conditions. An elastic model consisting of two Timoshenko beams attached with an elastic layer is derived to obtain simple analytical estimate of the specimen deformation from which a simple data reduction procedure is proposed. Taking benefit of the specimen symmetry, a proper experimental arrangement allows to separate the mode I and mode II contributions. Such protocol is less affected by the experimental artifacts which are observed on classical force versus displacement measurements from which are based the traditional fracture mechanics data reduction protocols. Additionally, backface strain measurements show superior sensitivity to non-linear interface behavior which should improve the quality of cohesive zone models identification. (C) 2014 Elsevier Ltd. All rights reserved.

引用

页码：222 / 232

页数：11

共 49 条

[31]

Juntti M, 1999, J COMPOS TECH RES, V21, P37, DOI 10.1520/CTR10611J

[32] Predicting fatigue damage in adhesively bonded joints using a cohesive zone model [J].