Improvement of Machinability Using Eco-Friendly Cutting Oil in Turning Duplex Stainless Steel

被引：17

作者：

Ghatge, Dayanand Ananda ^{[1
]}

Ramanujam, R. ^{[1
]}

Reddy, Sudhakar B. ^{[1
]}

Vignesh, M. ^{[1
]}

机构：

[1] VIT Univ, Sch Mech Engn, Vellore 632014, Tamil Nadu, India

来源：

MATERIALS TODAY-PROCEEDINGS | 2018年 / 5卷 / 05期

关键词：

vegetable oils; nano emulsions; machining experiments; surface roughness; MINIMUM QUANTITY LUBRICATION; SURFACE-ROUGHNESS; AISI-1040; STEEL; FLUIDS; MQL;

D O I：

10.1016/j.matpr.2018.02.208

中图分类号：

T [工业技术];

学科分类号：

08 ;

摘要：

In this work, currently used non-biodegradable mineral oil as a cutting fluid during machining is replaced with vegetable oil. In this work, duplex stainless steel is machined (turned) with the vegetable oils like coconut oil and neem oil. As a first step, vegetable oil based oil-in-water nano-emulsions were formulated using non-ionic surfactant (Tween-80) by ultrasonic emulsification method. In the second step, spindle speed, feed rate, depth of cut and type of cutting fluid are varied at three levels and Taguchi L27 machining experiments were performed. Measurement of surface roughness, tool wear and tool temperature were done as an output performance measure. From the results, it is evident that the order of influence for the improvement of tool wear and surface roughness are cutting fluid, feed rate and depth of cut respectively. (C) 2017 Elsevier Ltd. All rights reserved. Selection and/or Peer-review under responsibility of International Conference on Materials Manufacturing and Modelling (ICMMM - 2017).

引用

页码：12303 / 12310

页数：8

共 14 条

[11] Experimental Investigation of Minimum Quantity Lubrication (MQL) as a Sustainable Cooling Technique [J].

Rahim, E. A. ;

Ibrahim, M. R. ;

Rahim, A. A. ;

Aziz, S. ;

Mohid, Z. .

12TH GLOBAL CONFERENCE ON SUSTAINABLE MANUFACTURING - EMERGING POTENTIALS, 2015, 26 :351-354

[12] Optimization of Machining Parameters Using Fuzzy Based Principal Component Analysis during dry turning operation of Inconel 625-A hybrid approach [J].

Ramanujam, R. ;

Venkatesan, K. ;

Saxena, Vimal ;

Pandey, Rachit ;

Harsha, T. ;

Kumar, Gurusharan .

12TH GLOBAL CONGRESS ON MANUFACTURING AND MANAGEMENT (GCMM - 2014), 2014, 97 :668-676

[13]

Ramanujam R., 2014, ARPN J ENG APPL SCI, V9, P630

[14] Determining the influence of cutting fluids on tool wear and surface roughness during turning of AISI 304 austenitic stainless steel [J].

Xavior, M. Anthony ;

Adithan, M. .

JOURNAL OF MATERIALS PROCESSING TECHNOLOGY, 2009, 209 (02) :900-909

← 1 2 →