Axial cutting of AA6061-T6 circular extrusions under impact using single- and dual-cutter configurations

Experimental and numerical axial cutting of AA6061-T6 circular extrusions under both dynamic and quasi-static loading conditions were completed using single- and dual-cutter configurations to investigate load/displacement and collapse behaviour of the extrusions. Circular specimens with various wall thicknesses were considered for impact and quasi-static testing in this research. A steel cutter (AISI 4140) with four blades, having blade tip widths of 1.0 mm or 0.75 mm and blade lengths of 7 mm or 26.1 mm were used to cut through the extrusions. Straight and curved deflector profiles were used to flare the cut petalled sidewalls and facilitate the cutting system. Further quasi-static cutting tests using dual cutters were completed with or without the presence of a spacer to examine the load/displacement response as an adaptive energy absorption system. Results from the experimental impact tests illustrated that a higher peak cutting force, with a magnitude of approximately 1.09-1.98 times that of the force necessary under quasi-static testing conditions, was needed to initiate the cutting deformation mode. After this initial high force, the load/displacement responses were observed to be similar to those from the quasi-static tests with the exception of minor variations which resulted from material fracture that occurred on the petalled sidewalls during dynamic testing. Larger lengths of cutter blades and the curved deflector eased the flaring of the petalled sidewalls and reduced the occurrence of material fracture. The blade tip width had minor effects on the initial peak cutting force and mean cutting forces for extrusions under impact loading. The mean cutting force from the dynamic tests was determined to be 0.82-1.2 times that from the quasi-static experimental tests. Finally, quasi-static axial crushing of extrusions was completed to compare crashworthiness measures with the adaptive energy absorption system under the cutting deformation mode. A finite element model incorporating an Eulerian formulation was selected for the numerical model to simulate the cutting process. Simulation results generally agreed well with the experimental tests with a maximum over prediction of approximately 33% and 18% for the cutting force under impact and quasi-static loading, respectively. (C) 2009 Elsevier Ltd. All rights reserved.