THE INFLUENCE OF MANUFACTURING OVERSIZING ON POST-WELDING DISTORTIONS OF THE FILLET WELDED JOINT

被引：5

作者：

Kozak, Janusz ^{[1
]}

Kowalski, Jakub ^{[1
]}

机构：

[1] Gdansk Univ Technol, Fac Ocean Engn & Ship Technol, Naurutowicza 11-12 St, PL-80233 Gdansk, Poland

来源：

POLISH MARITIME RESEARCH | 2015年 / 22卷 / 04期

关键词：

welding distortion; shipbuilding welding; welding angular distortion;

D O I：

10.1515/pomr-2015-0072

中图分类号：

U6 [水路运输]; P75 [海洋工程];

学科分类号：

0814 ; 081505 ; 0824 ; 082401 ;

摘要：

Welding proces is basic joining technique in shipbuilding. Such method generated welding distortions which cause a lot of problems during the manufacturing process. In the literature it is proposed wide spectrum of suggestions for a correct estimation of welding deformation in particular angular deformation in the fillet welded T joint. In the work influence of oversizing of weld on angular distortions of joint is presented basing upon of the results of the laboratory measurements. Values determined on the basis of literature hypotheses are compared with the one obtained from the laboratory test.

引用

页码：59 / 63

页数：5

共 13 条

[1]

[Anonymous], 2014, HULL 2

[2]

[Anonymous], 2014, THESIS GDANSK U TECH

[3]

[Anonymous], 2003, ENG GUIDEBOOK WELDIN

[4]

[Anonymous], 1999, PREDICTIVE FORMULAE

[5]

Czajkowski H., 1987, TECHNOLOGY WELDED ST

[6]

Ferenc J., 2000, WELDED STRUCTURES JO

[7]

Gawroniak N., 1997, PRINCIPLES WELDING T

[8]

Jung GH, 2003, THESIS OHIO STATE U

[9] PROBLEMS OF DETERMINATION OF WELDING ANGULAR DISTORTIONS OF T - FILLET JOINTS IN SHIP HULL STRUCTURES [J].

Kozak, Janusz ;

Kowalski, Jakub .

POLISH MARITIME RESEARCH, 2015, 22 (02) :79-85

[10]

OBrien R.W., 2007, THESIS DURHAM U

← 1 2 →