Crack propagation in flexural fatigue of concrete

被引:96
作者
Kolluru, SV [1 ]
O'Neil, EF
Popovics, JS
Shah, SP
机构
[1] Northwestern Univ, Dept Civil Engn, NSF, Ctr Adv Cement Based Mat, Evanston, IL 60208 USA
[2] USA, Engineer Waterways Expt Stn, Concrete Mat Div, Vicksburg, MS 39180 USA
[3] Drexel Univ, Dept Civil & Architectural Engn, Philadelphia, PA 19104 USA
来源
JOURNAL OF ENGINEERING MECHANICS-ASCE | 2000年 / 126卷 / 09期
关键词
D O I
10.1061/(ASCE)0733-9399(2000)126:9(891)
中图分类号
TH [机械、仪表工业];
学科分类号
0802 ;
摘要
In this paper the behavior of concrete subjected to flexural fatigue loading is studied. Notched concrete beams were tested in a three-point bending configuration. Specimens were subjected to quasi-static cyclic and constant amplitude fatigue loading. The cyclic tests were performed by unloading the specimen at different points in the postpeak part of the quasi-static loading response. Low cycle, high amplitude fatigue tests were performed to failure using four different load ranges. The crack mouth opening displacement was continuously monitored throughout the loading process. Crack propagation caused by quasi-static and fatigue loads is described in terms of fracture mechanics. It is shown that the crack propagation in the postpeak part of the quasi-static load response is predicted using the critical value of the mode I stress intensity factor (K-1C). The ultimate deformation of the specimen during the fatigue test is compared with that from the quasi-static test; it is demonstrated that the quasi-static deformation is insufficient as a fatigue failure criterion. It is observed that crack growth owing to constant-amplitude fatigue loading comprises two phases: a deceleration stage when there is a decrease in crack growth rate with increasing crack length, followed by an acceleration stage where the rate of crack growth increases at a steady rate. The crack length where the rate of crack growth changes from deceleration to acceleration is shown to be equal to the crack length at the peak load of the quasi-static response. Analytical expressions for crack growth in the deceleration and acceleration stages are developed, wherein the expressions for crack growth rate in the deceleration stage are developed using the R-curve concept, and the acceleration stage is shown to follow the Paris law. It is observed that the crack length at failure for constant amplitude fatigue loading is comparable to that of the corresponding load in the postpeak part of the quasi-static response. Finally, a fracture-based fatigue failure criterion is proposed.
引用
收藏
页码:891 / 898
页数:8
相关论文
共 27 条
[1]  
*ACI COMM, 1982, PUBL SP, V75
[2]  
AGLAN HA, 1998, 1568 TRANSP RES BOAR, P17
[3]  
Baluch M.H., 1987, Proc., SEM/RILEM International Conference on Fracture of Concrete and Rock, Houston, P80
[4]  
BAZANT ZP, 1991, ACI MATER J, V88, P390
[5]  
BAZANT ZP, 1993, ACI MATER J, V90, P472
[6]  
GYLTOFT K, 1983, THESIS LULEA U TECHN
[7]  
HORDIJK DA, 1993, EXPT MECH, V83, P278
[8]  
HORDIJK DA, 1991, THESIS TU DELFT DELF
[9]   2 PARAMETER FRACTURE MODEL FOR CONCRETE [J].
JENQ, YH ;
SHAH, SP .
JOURNAL OF ENGINEERING MECHANICS-ASCE, 1985, 111 (10) :1227-1241
[10]  
Jun Z, 1998, ACI MATER J, V95, P58