Etching of porous SiOCH materials in fluorocarbon-based plasmas

This work focuses on the etching of different porous methylsilsesquioxane materials (spin on SiOCH,, k=2.2) with different porosity (30%, 40% and 50%) in fluorocarbon-based plasmas (CF4/Ar). The etching of these materials is performed on blanket wafers in a magnetically enhanced reactive ion etcher. The surface and bulk modification after partial etching are studied using different surface analysis techniques such as quasi-in-situ x-ray photoelectron spectroscopy (XPS), infrared spectroscopy (FTIR), and attenuated total reflection spectroscopy (FTIR-ATR). Similar to nonporous SiOCH materials, a decrease in-etch rate of porous SiOCH films is observed with either increasing Ar dilution or polymerizing gas addition (CH2F2), which can lead in this last case to an etch stop phenomenon. The etch rate increases with higher porosity in the SiOCH film, since less material per unit thickness needs to be removed as the porosity increases. The XPS results show that a fluorocarbon layer is formed at the surface of the porous material and complementary angle resolved XPS analyses reveal that fluorocarbon species diffuse through the pores into the material. After partial etching, FTIR and ATR analyses reveal a carbon depletion in the remaining film, which indicates that the porous material is altered during plasma exposure. The film degradation is more important as the porosity increases. The etch rate evolution and film degradation are discussed and interpreted in terms of etching mechanisms and plasma surface interaction. C 2004 American Vacuum Society.