Gas sensors based on piezoelectric micro-diaphragm transducer

We have fabricated high sensitive gas sensor based on piezoelectrically driven micro-diaphragm transducers. The micro-diaphragm transducer was fabricated using micro-electro-mechanical-system (MEMS) technique. The diol based sol-gel derived Pb(Zr-0.52,Ti-0.48)O-3(PZT) film was used as a piezoelectric actuating layer. We have used the resonant frequency change of micro-diaphragm transducer upon mass increase as a sensing signal. The resonant frequency values were measured by analysis of electrical signals from the micro-diaphragm transducer. The fundamental resonant frequency of the micro-diaphragm was in the range of 250 to 360 kHz, depending on their physical boundary conditions. The mass sensitivity of bare micro-diaphragm transducer was 66.5 Hz/ng. Two polymer sensing layers such as the polymethylmethacrylate (PMMA) and polydimethylsiloxane (PDMS) films were used to estimate the gas sensing behavior of microtransducers for various vapors of organic compounds. PMMA was used to detect primary alcohols while PDMS was used for toluene and benzene. The resonant frequency of micro-diaphragm transducer was shifted toward lower frequency range as the vapor concentration increased. With PMMA gas sensing layer, the micro-diaphragm showed a gas sensitivity of 0.456 Hz/ppm for ethanol vapor. When the PDMS gas sensing layer was used, the micro-diaphragm showed a gas sensitivity of 0. 143 Hz/ppm for toluene vapor. When the test vapors were removed from the reaction chamber, the resonant frequencies of micro-diaphragm sensors were completely recovered to their initial state.