Micro-electrode discharge machining of TiN/Si3N4 composites

被引：46

作者：

Liu, CC ^{[1
]}

Huang, JL ^{[1
]}

机构：

[1] Natl Cheng Kung Univ, Dept Mat Sci & Engn, Tainan 701, Taiwan

来源：

BRITISH CERAMIC TRANSACTIONS | 2000年 / 99卷 / 04期

关键词：

D O I：

10.1179/096797800680866

中图分类号：

TQ174 [陶瓷工业]; TB3 [工程材料学];

学科分类号：

0805 ; 080502 ;

摘要：

The feasibility of machining TiN/Si3N4 composites by a micro-EDM method has been explored. Samples of composites containing two different sizes of TiN particles were prepared by hot pressing and the resulting materials characterised in terms of microstructure, strength, fracture toughness, and electrical resistivity. A low electrical resistivity of 1.25 x 10(-3) Omega cm(-1) was obtained in a 40 vol.-% composition. Micropores of 700 mum depth and 70 mum dia. were successfully machined into TiN/Si3N4 composites by the micro-EDM method. The results demonstrated the possibility of machining engineering ceramics by the micro-EDM method through the incorporation of conducting toughening phases. The size and content of TiN particles were found to have substantial effects on the strength, toughness, and electrical resistivity of the composites.

引用

页码：149 / 152

页数：4

共 25 条

[1]

AKIMUNE Y, 1997, J JPN CERAM SOC INT, P129

[2]

Bellosi A., 1992, Journal of the European Ceramic Society, V9, P83, DOI 10.1016/0955-2219(92)90049-J

[3]

BULJAN ST, 1987, AM CERAM SOC BULL, V66, P347

[4] BETA-SIALON CERAMICS WITH TIN PARTICLE INCLUSIONS [J].