Comparison of Dry Sliding Tribological Behavior of Nanostructured Al2O3-13 wt% TiO2 Coatings Prepared by High-Efficiency Supersonic Plasma Spraying and Atmospheric Plasma Spraying

被引:3
作者
Jin, Zi-ang [1 ]
Ma, Jian-long [2 ,3 ]
Zhu, Li-na [1 ,4 ]
Wang, Hai-dou [2 ]
Li, Guo-lu [5 ]
Liu, Ming [2 ]
机构
[1] China Univ Geosci Beijing, Sch Engn & Technol, Beijing 100083, Peoples R China
[2] Acad Armored Forces Engn, Natl Key Lab Remfg, Beijing 100072, Peoples R China
[3] Hebei Univ Technol, Sch Mat Sci & Engn, Tianjin 300130, Peoples R China
[4] China Univ Geosci Beijing, Zhengzhou Inst, Zhengzhou 451283, Peoples R China
[5] Hebei Univ Technol, Sch Materfials Sci & Engn, Tianjin 300130, Peoples R China
来源
JOURNAL OF TRIBOLOGY-TRANSACTIONS OF THE ASME | 2021年 / 143卷 / 07期
基金
中国国家自然科学基金;
关键词
high-efficiency supersonic plasma spraying; nanostructured Al2O3-13 wt% TiO2 coatings; micromorphology; wear mechanism; ALUMINA-TITANIA COATINGS; MECHANICAL-PROPERTIES; WEAR BEHAVIOR; MICROSTRUCTURE; DEPENDENCY; FRICTION;
D O I
10.1115/1.4048886
中图分类号
TH [机械、仪表工业];
学科分类号
0802 ;
摘要
Plasma-sprayed ceramic coatings have been widely used in friction and wear protection of mechanical parts. In this paper, the nanostructured Al2O3-13 wt% TiO2 coatings were prepared by high-efficiency supersonic plasma spraying (HESP) and atmospheric plasma spraying (APS), respectively. The surface and section morphology of the coatings were observed by scanning electron microscopy (SEM). The phase composition of the coatings was analyzed by X-ray diffraction (XRD). The dry sliding friction properties of the coatings were tested on UMT-3 friction and wear testing machine. The results show that after plasma spraying, a large amount of gamma-Al2O3 phase appears, while the TiO2 phase almost disappears in the coatings; compared with APS, the coatings sprayed by HESP have fewer defects and better coating quality; under dry friction condition, the steady-state friction coefficient of the coatings sprayed by HESP and APS all decreases with the increase of load, and the wear volume all increases with the increase of load. When the load is more than 40 N, wear volume of the coatings sprayed by APS is basically twice that of HESP; the wear mechanism of the coatings sprayed by HESP is the laminar cracking, peeling off and the adhesive wear.
引用
收藏
页数:10
相关论文
共 30 条
  • [1] Effect of TiO2 addition on the microstructure and nanomechanical properties of Al2O3 Suspension Plasma Sprayed coatings
    Bannier, E.
    Vicent, M.
    Rayon, E.
    Benavente, R.
    Salvador, M. D.
    Sanchez, E.
    [J]. APPLIED SURFACE SCIENCE, 2014, 316 : 141 - 146
  • [2] Tribological Behavior of Plasma-Sprayed Al2O3-20 wt.%TiO2 Coating
    Cui, Shiyu
    Miao, Qiang
    Liang, Wenping
    Zhang, Zhigang
    Xu, Yi
    Ren, Beilei
    [J]. JOURNAL OF MATERIALS ENGINEERING AND PERFORMANCE, 2017, 26 (05) : 2086 - 2094
  • [3] Microstructure development of Al2O3-13wt.%TiO2 plasma sprayed coatings derived from nanocrystalline powders
    Goberman, D
    Sohn, YH
    Shaw, L
    Jordan, E
    Gell, M
    [J]. ACTA MATERIALIA, 2002, 50 (05) : 1141 - 1152
  • [4] Effects of cylinder liner surface topography on friction and wear of liner-ring system at low temperature
    Grabon, Wieslaw
    Pawlus, Pawel
    Wos, Slawomir
    Koszela, Waldemar
    Wieczorowski, Michal
    [J]. TRIBOLOGY INTERNATIONAL, 2018, 121 : 148 - 160
  • [5] Microstructure and Corrosion Behavior of Aluminum Coatings Prepared by High-Efficiency Supersonic Plasma Spraying and Oxygen-Acetylene Flame Spraying
    Jin, Zi-ang
    Liu, Ming
    Zhu, Li-na
    Wang, Hai-dou
    Ma, Guo-zheng
    Xing, Zhi-guo
    Kang, Jia-jie
    Chen, Shu-ying
    [J]. JOURNAL OF THERMAL SPRAY TECHNOLOGY, 2020, 29 (03) : 489 - 499
  • [6] Microstructures and Wear Resistance of Al-25 wt.%Si Coatings Prepared by High-Efficiency Supersonic Plasma Spraying
    Jin, Zi-ang
    Zhu, Li-na
    Wang, Hai-dou
    Liu, Ming
    Kang, Jia-jie
    Ma, Guo-zheng
    Chen, Shu-ying
    [J]. JOURNAL OF THERMAL SPRAY TECHNOLOGY, 2019, 28 (06) : 1308 - 1317
  • [7] Fabrication and evaluation of plasma sprayed nanostructured alumina-titania coatings with superior properties
    Jordan, EH
    Gell, M
    Sohn, YH
    Goberman, D
    Shaw, L
    Jiang, S
    Wang, M
    Xiao, TD
    Wang, Y
    Strutt, P
    [J]. MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING, 2001, 301 (01): : 80 - 89
  • [8] Bimodal distribution characteristic of microstructure and mechanical properties of nanostructured composite ceramic coatings prepared by supersonic plasma spraying
    Kang, Jia-jie
    Ma, Jian-long
    Li, Guo-lu
    Wang, Hai-dou
    Xu, Bin-shi
    Wang, Cheng-biao
    [J]. MATERIALS & DESIGN, 2014, 64 : 755 - 759
  • [9] Laser remelting of plasma-sprayed conventional and nanostructured Al2O3-13 wt.%TiO2 coatings on titanium alloy
    Li, Chonggui
    Wang, You
    Guo, Lixin
    He, Junqi
    Pan, Zhaoyi
    Wang, Liang
    [J]. JOURNAL OF ALLOYS AND COMPOUNDS, 2010, 506 (01) : 356 - 363
  • [10] Effects of argon gas flow rate on the microstructure and micromechanical properties of supersonic plasma sprayed nanostructured Al2O3-13 wt.%TiO2 coatings
    Li, Guo-lu
    Ma, Jian-long
    Wang, Hai-dou
    Kang, Jia-jie
    Xu, Bin-shi
    [J]. APPLIED SURFACE SCIENCE, 2014, 311 : 124 - 130