Strain Rate Sensitivity Variation in CuZr-based Bulk Metallic Glass Composites Containing B2-CuZr Phase

被引:0
作者
Ran, Wei [1 ]
Yun, Chang [1 ]
Sen, Yang [1 ]
Zhang Changjun [2 ]
Lin, He [1 ]
机构
[1] Xi An Jiao Tong Univ, State Key Lab Mech Behav Mat, Xian 710049, Peoples R China
[2] Changan Univ, Xian 710064, Peoples R China
基金
中国国家自然科学基金;
关键词
bulk metallic glass; metallic composite; strain rate sensitivity; martensitic transformation; shear band; COMPRESSIVE BEHAVIOR; DEFORMATION BEHAVIORS; MECHANICAL-PROPERTIES; MATRIX COMPOSITES; DUCTILITY; STRENGTH; DEPENDENCE; FAILURE; STEELS;
D O I
暂无
中图分类号
T [工业技术];
学科分类号
08 ;
摘要
The strain rate sensitivity (SRS) of CuZr-based bulk metallic glass composites (BMGCs) containing a B2-CuZr phase with different volume fractions was investigated by performing uniaxial compression tests in a strain-rate-jump mode. It is found that the SRS exponents of the BMGCs can vary from negative to positive in the strain-rate range from 3.7x10(-5) s(-1) to 3.7x10(-3) s(-1) with increasing of the B2-CuZr phase volume fraction. However, the positive SRS exponent of the BMGC with a higher B2-CuZr phase volume fraction up to about 80% is still unexpectedly low. This is attributed to the limited strain-rate-dependence of mechanical behavior of the B2-CuZr phase, which is induced by the martensitic transformation effect of the phase during deformation. It is obvious that the SRS ceiling of the CuZr-based BMGCs is controlled by the B2-CuZr phase.
引用
收藏
页码:542 / 547
页数:6
相关论文
共 41 条
[1]   The dynamic compressive behavior of beryllium bearing bulk metallic glasses [J].
Bruck, HA ;
Rosakis, AJ ;
Johnson, WL .
JOURNAL OF MATERIALS RESEARCH, 1996, 11 (02) :503-511
[2]   Strain rate dependent shear banding behavior of a Zr-based bulk metallic glass composite [J].
Chen, J. H. ;
Jiang, M. Q. ;
Chen, Y. ;
Dai, L. H. .
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING, 2013, 576 :134-139
[3]   Mechanical behavior of metallic glasses: Microscopic understanding of strength and ductility [J].
Chen, Mingwei .
ANNUAL REVIEW OF MATERIALS RESEARCH, 2008, 38 :445-469
[4]  
Dubach A, 2006, APPL PHYS LETT, V89
[5]   Constitutive model for inhomogeneous flow in bulk metallic glasses [J].
Dubach, Alban ;
Dalla Torre, Florian H. ;
Loeffler, Joerg F. .
ACTA MATERIALIA, 2009, 57 (03) :881-892
[6]   Strain rate sensitivity in superelasticity [J].
Entemeyer, D ;
Patoor, E ;
Eberhardt, A ;
Berveiller, M .
INTERNATIONAL JOURNAL OF PLASTICITY, 2000, 16 (10-11) :1269-1288
[7]   Deformation and strain rate sensitivity of a Zr-Cu-Fe-Al metallic glass [J].
Gonzalez, S. ;
Xie, G. Q. ;
Louzguine-Luzgin, D. V. ;
Perepezko, J. H. ;
Inoue, A. .
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING, 2011, 528 (09) :3506-3512
[8]   High strength Fe-Mn-(Al, Si) TRIP/TWIP steels development -: properties -: application [J].
Grässel, O ;
Krüger, L ;
Frommeyer, G ;
Meyer, LW .
INTERNATIONAL JOURNAL OF PLASTICITY, 2000, 16 (10-11) :1391-1409
[9]   Bulk metallic glasses: At the cutting edge of metals research [J].
Greer, A. L. ;
Ma, E. .
MRS BULLETIN, 2007, 32 (08) :611-615
[10]   Shear bands in metallic glasses [J].
Greer, A. L. ;
Cheng, Y. Q. ;
Ma, E. .
MATERIALS SCIENCE & ENGINEERING R-REPORTS, 2013, 74 (04) :71-132