Thermal stability and mechanical properties of HVOF/PVD duplex ceramic coatings produced by HVOF and cathodic vacuum arc

被引:33
|
作者
Chen, Wanglin [1 ,2 ]
Fang, Bo [1 ]
Zhang, Daoda [3 ]
Meng, Xianna [4 ]
Zhang, Shihong [1 ,2 ]
机构
[1] Anhui Univ Technol, Sch Mat Sci & Engn, Maanshan City 243002, Anhui, Peoples R China
[2] Anhui Univ Technol, Res Ctr Modern Surface & Interface Engn, Maanshan City 243002, Anhui, Peoples R China
[3] Jiangxi Mech Sci Inst, Nanchang 330000, Jiangxi, Peoples R China
[4] Anhui Univ Technol, Sch Met Engn, Maanshan City 243002, Anhui, Peoples R China
基金
中国国家自然科学基金;
关键词
NiCr-Cr3C2-based coating; AICrN film; Duplex ceramic coating; Thermal stability; Mechanical property; HIGH-STRENGTH STEEL; SPINODAL DECOMPOSITION; AB-INITIO; SURFACE; PVD; TI1-XALXN; BEHAVIOR; SYSTEM; ALCRN; TI;
D O I
10.1016/j.ceramint.2017.02.151
中图分类号
TQ174 [陶瓷工业]; TB3 [工程材料学];
学科分类号
0805 ; 080502 ;
摘要
Duplex ceramic coatings, consisting of an inner NiCr-Cr3C2-based coating and an outmost AJCrN film, were produced on the steel substrate in succession by velocity oxygen-fuel spraying (HVOF) and cathodic vacuum arc methods, and then isochronally annealed at annealing temperatures below 900 degrees C for 2 h. The thermal stability and mechanical properties of the annealed samples were systematically studied by means of X-ray diffraction, Optical microscope and transmission electron microscope, in association with mechanical property measurements. The results show that the microstructure, phase evolution and mechanical properties of duplex ceramic coatings are significantly dependent on the annealing temperature. Metastable fcc-AlCrN solid solution in AlCrN film first decomposes to rich-Al and rich-Cr domains by spinodal decomposition at 700 degrees C, leading to a notable increase in hardness due to its smaller grain size and high elastic strain field, and then to equiaxed hcp-AlN and Cr2N by the nucleation and growth at 900 degrees C, leading to a notable decrease in hardness due to the recrystallization and the formation of hcp-AIN. Meanwhile, the both decarburization of Cr3C2 to Cr2C3 occurs at 800 degrees C, but becomes more intensive at 900 degrees C, leading to a notable loss in hardness. In addition, the dissolution of Cr3C2 produces high density of porosity, which also reduces the hardness. The hardness tests show the following ordering of load-bearing capacity for the duplex ceramic coatings: 700 degrees C > As-deposited > 800 degrees C > 900 degrees C. Tribological property measurements demonstrate that the wear resistance of the tested duplex ceramic coatings obeys the following ordering: 700 degrees C > As-deposited > 800 degrees C > 900 degrees C. The improved wear resistance is due to high surface hardness, load-bearing capacity and thermal stability. In addition, the wear mechanisms are shown.
引用
收藏
页码:7415 / 7423
页数:9
相关论文
共 50 条
  • [1] Effect of different HVOF coatings on the tribological behavior of PVD/ HVOF duplex coatings
    Liu, Li
    Shao, Lei
    Li, Wensheng
    Shang, Lunlin
    Zhu, Bodun
    Wang, Canming
    Song, Qiang
    Zhang, Chunzhi
    TRIBOLOGY INTERNATIONAL, 2024, 198
  • [2] Influence of the WC grain size on the properties of PVD/HVOF duplex coatings
    Tillmann, Wolfgang
    Stangier, Dominic
    Hagen, Leif
    Schroeder, Philipp
    Krabiell, Marius
    SURFACE & COATINGS TECHNOLOGY, 2017, 328 : 326 - 334
  • [3] Designs and preparation of advanced HVOF-PVD duplex coating by combination of HVOF and arc ion plating
    Chen, Wanglin
    Mao, Taojie
    Zhang, Baiyong
    Zhang, Shihong
    Meng, Xianna
    SURFACE & COATINGS TECHNOLOGY, 2016, 304 : 125 - 133
  • [4] MECHANICAL-PROPERTIES OF HVOF COATINGS
    BRANDT, OC
    JOURNAL OF THERMAL SPRAY TECHNOLOGY, 1995, 4 (02) : 147 - 152
  • [5] Mechanical properties of nanocrystalline HVOF coatings
    Hannula, SP
    Fält, T
    Turunen, E
    Manninen, T
    ECO-MATERIALS PROCESSING & DESIGN VII, 2006, 510-511 : 114 - 117
  • [6] Dielectric Properties of HVOF Sprayed Ceramic Coatings
    Niittymaki, Minna
    Lahti, Kari
    Suhonen, Tomi
    Kanerva, Ulla
    Metsajoki, Jarkko
    PROCEEDINGS OF THE 2013 IEEE INTERNATIONAL CONFERENCE ON SOLID DIELECTRICS (ICSD 2013), VOLS 1 AND 2, 2013, : 389 - 392
  • [7] Load Bearing Capacity and Failure Modes Analysis of PVD/HVOF Duplex Coatings
    Bemporad, Edoardo
    Sebastiani, Marco
    Carassiti, Fabio
    SPECIAL TOPICS ON MATERIALS SCIENCE AND TECHNOLOGY: AN ITALIAN PANORAMA, 2009, : 25 - 34
  • [8] Nanostructured Cermet Coatings with Enhanced Properties Produced by HVOF Thermal Spray
    Dosta, S.
    Miguel, J. R.
    Guilemany, J. M.
    ADVANCED MATERIALS FORUM IV, 2008, 587-588 : 1024 - 1028
  • [9] CERAMIC COATINGS OBTAINED BY MEANS OF HVOF THERMAL SPRAYING
    GUILEMANY, JM
    LLORCAISERN, N
    NUTTING, J
    POWDER METALLURGY INTERNATIONAL, 1993, 25 (04): : 176 - 176
  • [10] Improved mechanical properties by nanoreinforced HVOF-sprayed ceramic composite coatings
    Turunen, Eria
    Varis, Tommi
    Gustafsson, Tom. E.
    Keskinen, Jari
    Lintunen, Pertti
    Lintula, Pekka
    Hannula, Simo-Pekka
    APPLIED MATERIAL RESEARCH AT VTT, 2006, : 188 - +