Low temperature CO and CH4 dual selective gas sensor using SnO2 quantum dots prepared by sonochemical method

被引:106
作者
Sedghi, S. Mosadegh [2 ]
Mortazavi, Y. [1 ]
Khodadadi, A. [2 ]
机构
[1] Univ Tehran, Nanoelect Ctr Excellence, Tehran, Iran
[2] Univ Tehran, Sch Chem Engn, Catalysis & Nanostructured Mat Res Lab, Tehran, Iran
关键词
Sonochemical; SnO2 quantum dots; Chemical gas sensor; Low temperature CO sensor; Selective gas sensor; TIN OXIDE; SONOCRYSTALLIZATION; NANOPARTICLES; NANORIBBONS; SENSITIVITY; DEPOSITION; NANORODS; IRON;
D O I
10.1016/j.snb.2009.11.002
中图分类号
O65 [分析化学];
学科分类号
070302 ; 081704 ;
摘要
In this study, a low temperature sensor with a dual function property is fabricated by using 3-4 nm SnO2 quantum dots (QDs) prepared by sonication-assisted precipitation. The sensor shows high selectivity to CO in the presence of methane below 375 degrees C. SnCl4 aqueous solution was precipitated by ammonia under sonication, which continued for 1,2 and 3 h. A part of the sample was then dried and calcined at 400 degrees C for 1.5 h and characterized by XRD and BET. UV-vis analyses were carried out for band gap measurements. The average particle size and the specific surface area of the SnO2 QDs as well as their sensing properties were compared with the SnO2 nano-particles prepared by conventional sol-gel method. The BET surface area of sonochemically as-prepared product after 2 h sonication and the one calcined at 400 degrees C after 1.5 h are 257 and 212 m(2)/g, respectively while the specific surface area for SnO2 prepared by conventional sol-gel method is about 80 m(2)/g. XRD spectra revealed pure crystalline phase of SnO2 is formed for both as-prepared and calcined samples of SnO2 QDs. However, for the sample prepared by sol-gel method and calcined at 400 degrees C, SnO crystals are detected along with the SnO2 crystals. Band gap measurements for the sample fabricated by sonochemical method and calcined at 400 degrees C indicated band gap energy of 5.7 eV which shows 2.1 eV blue-shift (shift into smaller wave lengths) from that of the bulk SnO2 which was reported earlier by others. Quantum dots of SnO2 show exceedingly high response to different concentrations of 100, 300 and 1000 ppm of CO in a temperature range of 25-350 degrees C. At about 50 degrees C a response of 27 was obtained for 1000 ppm CO, which increases to a maximum of 147 at 225 degrees C and then decreases whereas the maximum of 47.2 was detected for the SnO2 sample prepared by the sol-gel method occurred at about 300 degrees C. At the same time no response to methane is observed in the whole range of temperatures for SnO2 QDs. On the other hand the response to methane is higher than that to CO at above 375 degrees C. (C) 2009 Elsevier B.V. All rights reserved.
引用
收藏
页码:7 / 12
页数:6
相关论文
共 50 条
  • [21] Highly sensitive and low operating temperature SnO2 gas sensor doped by Cu and Zn two elements
    Zhang, Wenlong
    Yang, Bin
    Liu, Jingquan
    Chen, Xiang
    Wang, Xiaolin
    Yang, Chunsheng
    SENSORS AND ACTUATORS B-CHEMICAL, 2017, 243 : 982 - 989
  • [22] Fe-doped SnO2 nanomaterial:: A low temperature hydrogen sulfide gas sensor
    Vaishampayan, Mukta V.
    Deshmukh, Rupah G.
    Walke, Pravin
    Mulla, I. S.
    MATERIALS CHEMISTRY AND PHYSICS, 2008, 109 (2-3) : 230 - 234
  • [23] Highly Sensitive and Selective Hydrogen Gas Sensor Using the Mesoporous SnO2 Modified Layers
    Xue, Niuzi
    Zhang, Qinyi
    Zhang, Shunping
    Zong, Pan
    Yang, Feng
    SENSORS, 2017, 17 (10)
  • [24] Room Temperature Gas Sensor with a High Sensitivity to Hydrogen Based on SnO2 Films Prepared by Photochemical Techniques
    Ichimura, Masaya
    Sueyoshi, Tetsuya
    JAPANESE JOURNAL OF APPLIED PHYSICS, 2009, 48 (01)
  • [25] Highly selective and sensitive CH4 gas sensors based on flame-spray-made Cr-doped SnO2 particulate films
    Bunpang, K.
    Wisitsoraat, A.
    Tuantranont, A.
    Singkammo, S.
    Phanichphant, S.
    Liewhiran, C.
    SENSORS AND ACTUATORS B-CHEMICAL, 2019, 291 : 177 - 191
  • [26] Uniform hierarchical tetradecahedral SnO2/Zn2SnO4 composites for ultrafast response/recovery and selective gas detection at room temperature
    Chen, Zi-Yang
    Jiang, Da-Peng
    Zhang, Shao-Hui
    Wang, Chao
    Huang, Hui
    Zhang, Long
    Ding, Liu-Yi
    Wang, Lin-Jun
    Pan, Ge-Bo
    CHEMICAL PHYSICS LETTERS, 2020, 741
  • [27] SnO2 quantum dots decorated on RGO: a superior sensitive, selective and reproducible performance for a H2 and LPG sensor
    Mishra, R. K.
    Upadhyay, S. B.
    Kushwaha, Ajay
    Kim, Tae-Hyung
    Murali, G.
    Verma, Ranjana
    Srivastava, Manish
    Singh, Jay
    Sahay, P. P.
    Lee, Seung Hee
    NANOSCALE, 2015, 7 (28) : 11971 - 11979
  • [28] In depth study on the notable room-temperature NO2 gas sensor based on CuO nanoplatelets prepared by sonochemical method: Comparison of various bases
    Oosthuizen, D. N.
    Motaung, D. E.
    Swart, H. C.
    SENSORS AND ACTUATORS B-CHEMICAL, 2018, 266 : 761 - 772
  • [29] THE TEMPERATURE-DEPENDENCE OF THE RESPONSE OF SNO2-BASED GAS-SENSING LAYERS TO O-2, CH4, AND CO
    BARSAN, N
    TOMESCU, A
    SENSORS AND ACTUATORS B-CHEMICAL, 1995, 26 (1-3) : 45 - 48
  • [30] Preparation and gas-sensing properties of SnO2/graphene quantum dots composites via solvothermal method
    Chu, Xiangfeng
    Wang, Jiulin
    Zhang, Jun
    Dong, Yongping
    Sun, Wenqi
    Zhang, Wangbing
    Bai, Linshan
    JOURNAL OF MATERIALS SCIENCE, 2017, 52 (16) : 9441 - 9451