Two roll mill developments

被引：0

作者：

Blaik, J. ^{[1
]}

Chohan, P. ^{[2
]}

Garson, C. ^{[1
]}

Modolo, R. ^{[3
]}

机构：

[1] Bundaberg Walkers Engn Ltd, Bundaberg, Qld, Australia

[2] MSF Sugar Ltd Tablelands Mill, Mareeba, Qld, Australia

[3] Bundaberg Sugar Ltd, Bundaberg, Qld, Australia

来源：

INTERNATIONAL SUGAR JOURNAL | 2016年 / 118卷 / 1407期

关键词：

two roll mill; BHEM; development; stored bagasse;

D O I：

暂无

中图分类号：

S3 [农学（农艺学）];

学科分类号：

0901 ;

摘要：

The Bundaberg High Extraction Mill (BHEM) is a two roll crushing mill in which the flows of bagasse and extracted juice are co-current in a vertical down geometry. The first commercial installation of a BHEM was at Bundaberg Sugar's Bingera mill in 1997. Since then, the original Bingera BHEM has been replaced with a bigger unit and a further 12 units have been installed. As factories have increased their capacity, the BHEM concept has been further developed by retro-fitting pre-extraction rolls (PER) to the mills as a means of increasing their effective capacity. A small BHEM has also been installed at Millaquin mill where it is used to dry stored bagasse reclaimed from stockpiles so as to improve the fuel value of the stored bagasse prior to combustion in the factory's boilers. This paper describes these recent developments in BHEM technology.

引用

页码：186 / 190

页数：5

共 12 条

[1] [Anonymous], 1986, HDB CANE SUGAR ENG
[2] Batstone DB, 2001, INTERNATIONAL SOCIETY OF SUGAR CANE TECHNOLOGISTS, VOL I, PROCEEDINGS, P209
[3] BULLOCK K. J., 1957, PROC QUEENSLAND SOC SUGAR CANE TECHNOL, V24, P81
[4] Chohan P., 2009, Proceedings of the 2009 Conference of the Australian Society of Sugar Cane Technologists held at Ballina, New South Wales, Australia, 5-8 May 2009, P531
[5] Drury TJ, 2014, P AUSTR SOC SUGAR CA, V361, P517
[6] Garson C. A., 2008, Proceedings of the 2008 Conference of the Australian Society of Sugar Cane Technologists held at Townsville, Queensland, Australia, 29 April - 2 May 2008, P510
[7] Hatt RJ, 1998, United States Patent, Patent No. [6 039 276, 6039276]
[8] Kent G. A., 2000, Proceedings of the 2000 Conference of the Australian Society of Sugar Cane Technologists held at Bundaberg, Queensland, Australia, 2 May to 5 May 2000., P416
[9] Murry C.R., 1960, Ph.D. Thesis
[10] Rein P., 2007, Cane sugar engineering

← 1 2 →