Effect of Instrument Lubricants on the Surface Degree of Conversion and Crosslinking Density of Nanocomposites

被引：11

作者：

de Paula, Felipe Costa ^{[1
]}

Valentin, Regis de Souza ^{[1
]}

Dutra Borges, Boniek Castillo ^{[1
]}

dos Santos Medeiros, Maria Cristina ^{[1
]}

de Oliveira, Raiza Freitas ^{[2
]}

da Silva, Ademir Oliveira ^{[3
]}

机构：

[1] Fed Univ Rio Grande do Norte UFRN, Dept Dent, Av Sen Salgado Filho 1787, BR-59056000 Natal, RN, Brazil

[2] Fed Univ Rio Grande do Norte UFRN, Dept Mech Engn, Lab Tribol & Struct Integr, BR-59056000 Natal, RN, Brazil

[3] Fed Univ Rio Grande do Norte UFRN, Inst Chem, BR-59056000 Natal, RN, Brazil

来源：

JOURNAL OF ESTHETIC AND RESTORATIVE DENTISTRY | 2016年 / 28卷 / 02期

关键词：

RESIN COMPOSITE; COHESIVE STRENGTH; VISCOSITY; ADHESIVES;

D O I：

10.1111/jerd.12182

中图分类号：

R78 [口腔科学];

学科分类号：

1003 ;

摘要：

Purpose: The surface degree of conversion and crosslink density of composites should not be affected by the use of instrument lubricants in order to provide long-lasting tooth restorations. This study aimed to analyze the effect of instrument lubricants on the degree of conversion and crosslink density of nanocomposites. Materials and Methods: Samples (N=10) were fabricated according to the composites (Filtek Z350 XT, 3M ESPE, St. Paul, MN, USA; and IPS Empress Direct, Ivoclar Vivadent AG, Schaan, Liechtenstein and lubricants used (Adper Single Bond 2 and Scotchbond Multi-Purpose bonding agent adhesive systems, 3M ESPE; 70% ethanol, absolute ethanol, and no lubricant). Single composite increments were inserted into a Teflon mold using the same dental instrument. The composite surface was then modeled using a brush wiped with each adhesive system and a spatula wiped with each ethanol. The control group was fabricated with no additional modeling. The surface degree of conversion and crosslink density were measured by Fourier transform infrared spectroscopy and the hardness decrease test, respectively. Data were analyzed using two-way analysis of variance and the Tukey's test (p<0.05). Results: Filtek Z350 XT showed statistically similar degree of conversion regardless of the lubricant used, whereas the use of adhesive systems and 70% ethanol decreased the degree of conversion for IPS Empress Direct. Only Scotchbond Multi-Purpose bonding agent decreased crosslink density for Filtek Z350 XT, whereas both adhesive systems decreased crosslink density for IPS Empress Direct. Conclusion: Filtek Z350 XT appeared to be less sensitive to the effects of lubricants, and absolute ethanol did not affect the degree of conversion and crosslink density of the nanocomposites tested.

引用

页码：85 / 91

页数：7

共 25 条

[11]

Gajewski Vinícius E. S., 2012, Braz. Dent. J., V23, P508

[12] Influence of BisGMA, TEGDMA, and BisEMA contents on viscosity, conversion, and flexural strength of experimental resins and composites [J].