Noise attenuation by a hard wedge-shaped barrier

This paper is concerned with the problem of sound screening by a wedge-like barrier. The sound source is assumed to be point like, and the receiver is located in the shadow of the source sound field, so that according to geometrical optics only the field diffracted by the edge of the barrier is considered. First, for the hard wedge in space, three models are used for calculating the amplitude of the edge-diffracted field. These are the uniform theory of diffraction (UTD), the Hadden-Pierce model, both in the frequency domain, and the Biot-Tolstoy theory of diffraction which is a time domain formulation. It is first shown that even at relatively low frequencies, the frequency domain models perform quite satisfactorily as compared to the exact time domain theory. Hence, and due to its relative simplicity the UTD is proposed as an accurate calculation scheme for solving problems with edge diffraction by hard wedges. It is also proved from theoretical calculations that the amplitude of the edge-diffracted field increases for an increasing angle of the wedge, and consequently the hard half-plane gives the lowest field amplitude in the shadow zone. Some applications are then considered for evaluating the performance of a barrier on a flat ground, either completely hard or with mixed homogeneous boundary conditions. An improvement of the scheme for calculating the sound field in the all-hard case is achieved through considering the multiple diffraction, in this case only to the second order, between the top of the wedge barrier and its base. The results show that for usually occurring situations, increasing the angle of the hard wedge barrier affects negatively its efficiency through diminishing its insertion loss. These conclusions are also supported by the results of some experimental measurements conducted at a scale-model level. (C) 2002 Elsevier Science Ltd. All rights reserved.