Performance comparison of carbon fiber reinforced polyaryletherketone and epoxy composites: Mechanical properties, failure modes, cryo-thermal behavior, and finite element analysis

被引：18
作者：
Kumar, Painkal Sarath [1 ,2 ]
Jayanarayanan, Karingamanna [1 ,2 ]
Balachandran, Meera [1 ,2 ]
机构：
[1] Amrita Univ, Dept Chem Engn & Mat Sci, Amrita Sch Engn, Coimbatore Amrita Vishwa Vidyapeetham, Coimbatore, Tamil Nadu, India
[2] Amrita Univ, Coimbatore Amrita Vishwa Vidyapeetham, Amrita Sch Engn, Ctr Excellence Adv Mat & Green Technol CoE AMGT, Coimbatore, Tamil Nadu, India
来源：
JOURNAL OF APPLIED POLYMER SCIENCE | 2022年 / 139卷 / 29期
关键词：
carbon fiber; cryogenic; FEM; fracture toughness; polyaryletherketone; wear; INTERLAMINAR SHEAR-STRENGTH; POLY(ARYL ETHER KETONE); FIBER/EPOXY COMPOSITE; IMPACT BEHAVIOR; WEAR BEHAVIOR; NANOCOMPOSITES; NANOTUBES; SURFACE;
D O I：
10.1002/app.52494
中图分类号：
O63 [高分子化学（高聚物）];
学科分类号：
070305 ; 080501 ; 081704 ;
摘要：
High-performance thermoplastic composites are gaining attention as potential replacement for thermoset composites in high-end structural applications owing to their superior fracture toughness and recyclability. In this study, polyaryletherketone (PAEK) and carbon fabric (CF) reinforced PAEK are compared with epoxy and epoxy-CF composites. PAEK-CF composites are prepared by film stacking method followed by compression molding while hand lay-up technique was used for epoxy-CF composites. PAEK and PAEK-CF composites possess superior tensile properties, flexural strength and fracture toughness compared to those prepared from epoxy. The incorporation of CF improved the wear resistance in both PAEK and epoxy and PAEK-CF exhibited the lowest wear rate. The investigation of interlaminar shear strength of the composites was conducted and the highest value observed for PAEK-CF composite. Wear and fracture surface analysis suggested ductile failure for PAEK and PAEK-CF composites and brittle failure in epoxy composites, as indicated by interfacial bonding/debonding and fiber pullout, at the fracture surface. Cryo-thermal cycling effects on the tensile properties, fracture toughness and fracture surface morphology of the composites are studied. The failure behavior obtained from experimental studies was corroborated with finite element method-based simulation models of fracture toughness response in single edge notch bend test using Abaqus/Explicit.
引用
收藏
页数：16
相关论文
共 45 条
[1]   Thermal, mechanical and dielectric behaviour of poly(aryl ether ketone) with low melting temperature [J].
Audoit, Jeremie ;
Riviere, Lisa ;
Dandurand, Jany ;
Lonjon, Antoine ;
Dantras, Eric ;
Lacabanne, Colette .
JOURNAL OF THERMAL ANALYSIS AND CALORIMETRY, 2019, 135 (04) :2147-2157
[2]   Influence of micro-notches on the fatigue strength and crack propagation of unfilled and short carbon fiber reinforced PEEK [J].
Avanzini, A. ;
Petrogalli, C. ;
Battini, D. ;
Donzella, G. .
MATERIALS & DESIGN, 2018, 139 :447-456
[3]   Effect of fiber surface on flexural strength in carbon fabric reinforced epoxy composites [J].
Brocks, Thatiane ;
Hilario Cioffi, Maria Odila ;
Cornelis Voorwald, Herman Jacobus .
APPLIED SURFACE SCIENCE, 2013, 274 :210-216
[4]   Rate-dependent tensile failure behavior of short fiber reinforced PEEK [J].
Chen, Chunyang ;
Zhang, Chao ;
Liu, Chenlin ;
Miao, Yinggang ;
Wong, Shing-Chung ;
Li, Yulong .
COMPOSITES PART B-ENGINEERING, 2018, 136 :187-196
[5]   Permeability of carbon fibre PEEK composites for cryogenic storage tanks of future space launchers [J].
Flanagan, M. ;
Grogan, D. M. ;
Goggins, J. ;
Appel, S. ;
Doyle, K. ;
Leen, S. B. ;
Bradaigh, C. M. O. .
COMPOSITES PART A-APPLIED SCIENCE AND MANUFACTURING, 2017, 101 :173-184
[6]   Investigation of mechanical impact behavior of short carbon-fiber-reinforced PEEK composites [J].
Garcia-Gonzalez, D. ;
Rodriguez-Millan, M. ;
Rusinek, A. ;
Arias, A. .
COMPOSITE STRUCTURES, 2015, 133 :1116-1126
[7]   Wear behavior of PAEK, poly(aryl-ether-ketone), under physiological conditions, outlooks for performing these materials in the field of hip prosthesis [J].
Geringer, Jean ;
Tatkiewicz, Witold ;
Rouchouse, G. .
WEAR, 2011, 271 (11-12) :2793-2803
[8]   Influence of carbon nanotube reinforcement on the processing and the mechanical behaviour of carbon fiber/epoxy composites [J].
Godara, A. ;
Mezzo, L. ;
Luizi, F. ;
Warrier, A. ;
Lomov, S. V. ;
van Vuure, A. W. ;
Gorbatikh, L. ;
Moldenaers, P. ;
Verpoest, I. .
CARBON, 2009, 47 (12) :2914-2923
[9]   Experimental and multiscale modeling investigations of cryo-thermal cycling effects on the mechanical behaviors of carbon fiber reinforced epoxy composites [J].
Guo, Fang-Liang ;
Zhou, Zi-Li ;
Wu, Tao ;
Hu, Jin-Ming ;
Li, Yuan-Qing ;
Huang, Pei ;
Hu, Ning ;
Fu, Shao-Yun ;
Hong, Yang .
COMPOSITES PART B-ENGINEERING, 2022, 230
[10]  
Hamerton I., 2018, Thermosets, P303
12345