Experimental Study on Fluidization Behaviors of Wet Rice Threshed Materials with Hot Airflow

被引:6
|
作者
Zhang, Tao [1 ,2 ]
Li, Yaoming [1 ,2 ]
Xu, Lizhang [1 ,2 ]
Liu, Yanbin [1 ,2 ]
Ji, Kuizhou [1 ,2 ]
Jiang, Sheng [1 ,2 ]
机构
[1] Jiangsu Univ, Key Lab Modern Agr Equipment & Technol, Zhenjiang 212013, Jiangsu, Peoples R China
[2] Jiangsu Univ, Sch Agr Engn, Zhenjiang 212013, Jiangsu, Peoples R China
来源
AGRICULTURE-BASEL | 2022年 / 12卷 / 05期
基金
中国国家自然科学基金;
关键词
wet rice; adhesion; hot airflow; dispersion characteristic; minimum suspension speed; surface water content; SIMULATION; STABILITY; BED;
D O I
10.3390/agriculture12050601
中图分类号
S3 [农学(农艺学)];
学科分类号
0901 ;
摘要
Among food crops, rice has the largest planting area, the highest yield per unit area and the largest total yield in China. However, cleaning performance is reduced by the high moisture content of rice during the harvesting process. In order to decrease the adhesion among wet rice threshed mixtures and improve the cleaning performance, the method of hot airflow cleaning was proposed. Firstly, the fluidization characteristics of wet sticky rice under the action of hot air were compared with those of dry particles. In this work, the minimum suspension velocity and the fastest suspension time were used and quantified to characterize the fluidization characteristics. It was found that the minimum suspension velocity and the fastest suspension time of the wet rice threshed mixture are both higher than those of dry particles due to the liquid bridge force. Moreover, the dispersion degree of the wet rice threshed mixture can be improved by the hot airflow due to the decrease in the surface water content of impurities. Secondly, the influence of the temperature and vibration frequency in the air-and-screen cleaning device on the dispersion characteristics of the wet rice threshed mixture were investigated. The accumulation mass was measured to quantify the dispersion degree. It was found that the increase in vibration frequency has little effect on the dispersion of the wet rice threshed mixture. The accumulation mass on the front of the sieve decreases slightly with the increase in the gas temperature range from ambient temperature to 30 degrees C. Then, the dispersion degree increases rapidly when the temperature exceeds 40 degrees C. The dispersion effect is the best when the temperature is 50 degrees C and the vibration frequency is 5 Hz. These results provide a basis for the cleaning of the wet rice threshed mixture in a combine harvester.
引用
收藏
页数:13
相关论文
共 50 条
  • [41] An experimental study to improve cooling on a hot plate using phase change materials and high-frequency ultrasound
    Khanmohammadi, Shoaib
    Azimi, Neda
    Sharifzadeh, Esmail
    Rahimi, Masoud
    Azimi, Pedram
    JOURNAL OF ENERGY STORAGE, 2023, 72
  • [43] Experimental study on the properties of cement-based materials in hot-humid and sulfate rich tunnel environments
    Liu, Pin
    Han, Xiaolong
    Xia, Wei
    Xu, Xuefeng
    Cui, Shengai
    CASE STUDIES IN CONSTRUCTION MATERIALS, 2024, 20
  • [44] Experimental study on the burning behaviors of three typical thermoplastic materials liquid pool fire with different mass feeding rates
    Xin Ma
    Ran Tu
    Qiyuan Xie
    Yong Jiang
    Yanli Zhao
    Nan Wang
    Journal of Thermal Analysis and Calorimetry, 2016, 123 : 329 - 337
  • [45] Experimental study on the burning behaviors of three typical thermoplastic materials liquid pool fire with different mass feeding rates
    Ma, Xin
    Tu, Ran
    Xie, Qiyuan
    Jiang, Yong
    Zhao, Yanli
    Wang, Nan
    JOURNAL OF THERMAL ANALYSIS AND CALORIMETRY, 2016, 123 (01) : 329 - 337
  • [46] An experimental study of the drying of granular materials in a packed bed passed by hot air. The local temperature of the thermal agent
    Moise, A
    Tudose, RZ
    REVUE ROUMAINE DE CHIMIE, 2003, 48 (08) : 645 - 649
  • [47] Theoretical and experimental study on the anisotropic thermal conductivity of composite phase change materials prepared by hot-pressing method
    Mao, Li-Kai
    Zhao, Rui
    Chen, Jiong
    Cheng, Wen-Long
    INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER, 2022, 198
  • [48] Experimental study on properties and structure of magnesium alloy/PC/ABS hybrid materials prepared by hot-press molding technology
    Qiu, Jie
    Cai, Di
    Zhang, Xinxin
    Zhao, Qingyun
    Zhang, Weili
    Li, Youbing
    Xia, Tian
    Yang, Chaolong
    JOURNAL OF ADHESION SCIENCE AND TECHNOLOGY, 2023, 37 (19) : 2667 - 2682
  • [49] Experimental Study of Sulfoaluminate Cement-Based Rapid Repair Mortar Undergoing Hot/Wet Harsh Conditions: Mechanical Strengths, Hydration Products, and Ettringite Evolution Mechanism
    Hou, Xiangshan
    Li, Jingwei
    Xu, Jianwei
    Xiao, Xin
    Wang, Jianyong
    Liu, Yanhui
    Ossman, Mona
    Lin, Fawei
    Wang, Xujiang
    Li, Yuzhong
    Wang, Wenlong
    ACS SUSTAINABLE CHEMISTRY & ENGINEERING, 2024, 12 (27): : 10089 - 10101
  • [50] Experimental study on K migration, ash fouling/slagging behaviors and CO2 emission during co-combustion of rice straw and coal gangue
    Liu, Lang
    Ren, Shan
    Yang, Jian
    Jiang, Donghai
    Guo, Junjiang
    Pu, Yubao
    Meng, Xianpiao
    ENERGY, 2022, 251