Characterization of interfacial property of a two-layered plate using a nonlinear low-frequency Lamb wave approach

This work investigates the feasibility of using a nonlinear low-frequency Lamb wave approach for characterizing the interfacial property of a two-layered plate. Compared with the case of the exact phase-velocity matching, the approximate phase-velocity matching in the low-frequency region can still guarantee the cumulative secondharmonic generation (SHG) of primary Lamb wave propagation, which overcomes the drawbacks arising from the inherent dispersion and multimode features of Lamb wave propagation. For a given two-layered plate, the appropriate mode pair at low frequency consisting of primary Lamb wave and double-frequency Lamb wave (DFLW), which satisfies the approximate phase-velocity matching and nonzero energy flux, is selected to ensure that the amplitude of the generated second harmonic grows within the maximum cumulative distance (MCD). Meanwhile, the numerical analyses indicate that the variation of the SHG efficiency is maximized at the MCD during the interfacial degradation. Using the nonlinear ultrasonic measurement-based experimental setup, the time-domain signal of the second harmonic generated at different propagation distances is conveniently extracted, and then the relative nonlinear acoustic parameter curve consistent with the theoretical prediction is obtained. For examining the influence of interfacial property on the SHG effect of low-frequency Lamb wave propagation, the different annealing cycles of the thin adhesive layer (acrylics) are used to simulate minor changes in the interfacial property of the given two-layered plate. It is found that the relative nonlinear acoustic parameter at the MCD decreases monotonically and sensitively with the increment of annealing cycle number, which verifies the quantitative correlation between the SHG efficiency of low-frequency Lamb wave propagation and the degree of the interfacial degradation. The consistency between the numerical analysis and the experimental measurement shows the potential of using the SHG effect of low-frequency Lamb wave propagation to characterize a minor change in the interfacial properties of a layered composite plate.