Effect of cracks on dynamic parameters and lifetime of hydraulic units

被引:4
作者
Georgievskaia, E. [1 ]
机构
[1] JSC NPO CKTI, Atamanskaia St 3-6, St Petersburg 191167, Russia
来源
FIRST INTERNATIONAL SYMPOSIUM ON RISK ANALYSIS AND SAFETY OF COMPLEX STRUCTURES AND COMPONENTS (IRAS 2019) | 2019年 / 22卷
关键词
crack; hydraulic turbine; lifetime; runner; vibration state;
D O I
10.1016/j.prostr.2020.01.029
中图分类号
T [工业技术];
学科分类号
08 ;
摘要
Traditionally, an indicator of the reliability and quality of the hydraulic unit operation is the vibration state. However, numerous experiments show that there is often no correlation between the parameters measured during vibration tests and the level of dynamic stresses in runner the one of the main unit elements. At the same time, it is important to remember that the dynamic stresses predominantly determine the hydraulic unit lifetime. Moreover, as practice shows, most modern diagnostic systems of hydraulic units cannot identify cracks not only in the early stage, but in also having a sufficiently long size. The dynamic system "runner shaft support bearings" of the vertical Francis hydraulic unit was studied in this work. The aim of research was learning the effect of cracks on the vibration parameters measured during regular vibration tests. The calculations have shown that due to the high rigidity of the structure, the appearance of cracks almost no affected on changes in the frequency spectrum or vibration amplitudes. It was also found the presence of eigenvalues modes, the excitation of which is not accompanied by a vibration response on the support nodes, but causes dynamic stresses in the runner blades that eventually lead to cracking in the zone of joint of the blades with the hub or rim. This means that the existing diagnostic systems do not allow identifying cracks and, accordingly, not allow to correctly assessing the lifetime of the hydraulic unit or the time of safe operation up to needed repair. The conducted studies show the shortcomings of the existing diagnostic systems of hydraulic units from the standpoint of lifetime assessment and make it possible to determine the priority directions of their development for the near future. 2019 The Authors. Published by Elsevier B.V. This is an open access article under the CC BY-NC-ND license (http://creativecommons.orgilicenses/k -nc-ndi4.01) Peer-review under responsibility of the First International Symposium on Risk and Safety of Complex Structures and Components organizers
引用
收藏
页码:229 / 234
页数:6
相关论文
共 3 条
  • [1] Failure analysis of a Francis turbine runner
    Frunzaverde, D.
    Muntean, S.
    Marginean, G.
    Campian, V.
    Marsavina, L.
    Terzi, R.
    Serban, V.
    [J]. 25TH IAHR SYMPOSIUM ON HYDRAULIC MACHINERY AND SYSTEMS, 2010, 12
  • [2] Justification of the hydraulic turbines lifetime from the standpoint of the fracture mechanics
    Georgievskaia, Evgeniia
    [J]. ECF22 - LOADING AND ENVIRONMENTAL EFFECTS ON STRUCTURAL INTEGRITY, 2018, 13 : 971 - 975
  • [3] Hydrodynamic damping and stiffness prediction in Francis turbine runners using CFD
    Nennemann, Bernd
    Monette, Christine
    Chamberland-Lauzon, Joel
    [J]. 28TH IAHR SYMPOSIUM ON HYDRAULIC MACHINERY AND SYSTEMS (IAHR2016), PTS 1-12, 2016, 49