Plasticity induced by nanoindentation in a CrCoNi medium-entropy alloy studied by accurate electron channeling contrast imaging revealing dislocation-low angle grain boundary interactions

被引:19
作者
Habiyaremye, Frederic [1 ]
Guitton, Antoine [1 ,2 ]
Schafer, Florian [3 ]
Scholz, Felicitas [4 ]
Schneider, Mike [4 ]
Frenzel, Jan [4 ]
Laplanche, Guillaume [4 ]
Maloufi, Nabila [1 ,2 ]
机构
[1] Univ Lorraine, CNRS, Arts & Metiers, LEM3, F-57070 Metz, France
[2] Univ Lorraine, Labex Damas, F-57073 Metz, France
[3] Saarland Univ, Dept Mat Sci & Engn, D-66123 Saarbrucken, Germany
[4] Ruhr Univ Bochum, Inst Werkstoffe, Univ Str 150, D-44801 Bochum, Germany
来源
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING | 2021年 / 817卷
关键词
Dislocations; Low-angle grain boundary; NiCoCr medium-entropy alloy; A-ECCI; Nanoindentation; MECHANICAL-PROPERTIES; SLIP TRANSFER; DEFORMATION; STRESS; NUCLEATION; DEPENDENCE; NANOHARDNESS; TRANSMISSION; RESISTANCE; EVOLUTION;
D O I
10.1016/j.msea.2021.141364
中图分类号
TB3 [工程材料学];
学科分类号
0805 ; 080502 ;
摘要
In the present work, interactions of nanoindentation-induced dislocations (NIDs) with a low-angle grain boundary (LAGB) are investigated in a single-crystalline CrCoNi medium-entropy alloy (MEA). Microstructural evolutions before and after nanoindentation were examined using accurate electron channeling contrast imaging (A-ECCI). In the as-grown state, the alloy microstructure consists of subgrains separated by LAGBs. After nanoindentation on the (001) plane far away from LAGBs, the load-displacement curves exhibit the typical behavior of metals and alloys with a pop-in marking the elastic-plastic transition. This pop-in is related to the nucleation of NIDs that are observed to form pile-ups on {111} planes. In contrast, when indents are performed in the vicinity of a LAGB with a low misorientation angle of 0.24 degrees and consisting of dislocations spaced similar to 60 nm apart, different micromechanical responses and deformation mechanisms are observed depending on the distance between the LAGB and the nanoindenter tip. When the distance between the LAGB and the nanoindenter tip is larger than four times the size of the indent (corresponding ratio: R > 4), the LAGB does not affect the micromechanical response nor interact with NIDs. In contrast, when the indenter comes in direct or indirect contact with the LAGB (R < 1), the load-displacement curve deviates at low loads from the elastic stage, and popins are not observed. In this case, the continuous deformation is accommodated by the movement of the preexisting LAGB dislocations. For intermediate cases with 1 < R < 4, the load of the initial pop-in is dependent on the local defect density. In this latter case, the pile-ups of NIDs directly impinge on the LAGB. Microstructural analyses reveal that the LAGB accommodates plasticity by blocking the NIDs, activating a dislocation nucleation site in the adjacent subgrain/emission of dislocation from the LAGB, and inducing slight motions of its constituent dislocations.
引用
收藏
页数:11
相关论文
共 67 条
[1]   Critical resolved shear stress for slip and twin nucleation in single crystalline FeNiCoCrMn high entropy alloy [J].
Abuzaid, Wael ;
Sehitoglu, Huseyin .
MATERIALS CHARACTERIZATION, 2017, 129 :288-299
[2]   Ultra-low-angle boundary networks within recrystallizing grains [J].
Ahl, S. R. ;
Simons, H. ;
Zhang, Y. B. ;
Detlefs, C. ;
Stohr, F. ;
Jakobsen, A. C. ;
Jensen, D. Juul ;
Poulsen, H. F. .
SCRIPTA MATERIALIA, 2017, 139 :87-91
[3]   Review on slip transmission criteria in experiments and crystal plasticity models [J].
Bayerschen, E. ;
McBride, A. T. ;
Reddy, B. D. ;
Boehlke, T. .
JOURNAL OF MATERIALS SCIENCE, 2016, 51 (05) :2243-2258
[4]  
Beausir B., 2015, U LORRAINE METZ ATEX
[5]   Characterizing heterogeneous intragranular deformations in polycrystalline solids using diffraction-based and mechanics-based metrics [J].
Carson, Robert ;
Obstalecki, Mark ;
Miller, Matthew ;
Dawson, Paul .
MODELLING AND SIMULATION IN MATERIALS SCIENCE AND ENGINEERING, 2017, 25 (05)
[6]   Direct imaging and optical activities of stacking faults in 4H-SiC homoepitaxial films [J].
Chen, Bin ;
Matsuhata, Hirofumi ;
Kumagai, Kazuhiro ;
Sekiguchi, Takashi ;
Ichinoseki, Kyouichi ;
Okumura, Hajime .
JOURNAL OF APPLIED PHYSICS, 2012, 111 (05)
[7]   The role of low angle grain boundary in deformation of titanium and its size effect [J].
Chen, Sijing ;
Yu, Qian .
SCRIPTA MATERIALIA, 2019, 163 (148-151) :148-151
[8]   Strength prediction in NiCo alloys - The role of composition and nanotwins [J].
Chowdhury, P. ;
Sehitoglu, H. ;
Maier, H. J. ;
Rateick, R. .
INTERNATIONAL JOURNAL OF PLASTICITY, 2016, 79 :237-258
[9]   In situ TEM nanoindentation and dislocation-grain boundary interactions: a tribute to David Brandon [J].
De Hosson, Jeff T. M. ;
Soer, Wouter A. ;
Minor, Andrew M. ;
Shan, Zhiwei ;
Stach, Eric A. ;
Asif, S. A. Syed ;
Warren, Oden L. .
JOURNAL OF MATERIALS SCIENCE, 2006, 41 (23) :7704-7719
[10]   Using grain boundary engineering to evaluate the diffusion characteristics in ultrafine-grained Al-Mg and Al-Zn alloys [J].
Fujita, T ;
Horita, Z ;
Langdon, TG .
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING, 2004, 371 (1-2) :241-250