The lubrication characteristics of the vane tip under pressure boundary condition of oil hydraulic vane pump

被引：12

作者：

Cho, Ihn-Sung

Oh, Seok-Hyung

Song, Kyu-Keun

Jung, Jae-Youn ^{[1
]}

机构：

[1] Chonbuk Natl Univ, Div Mech & Aerosp Syst Engn, Jeonju 561756, Jeonbuk, South Korea

[2] Kunsan Natl Univ, Div Mech & Aerosp Syst Engn & RCIT, Fac MEch Engn, Kunsan 561756, South Korea

来源：

JOURNAL OF MECHANICAL SCIENCE AND TECHNOLOGY | 2006年 / 20卷 / 10期

关键词：

inlet pressure; outlet pressure; vane pump; vane tip; line contact; lubrication mode;

D O I：

10.1007/BF02916275

中图分类号：

TH [机械、仪表工业];

学科分类号：

0802 ;

摘要：

The Lubrication Mode of line contacts between the vane and the camring in an oil hydraulic vane pump has been investigated. First, the variations of the radial force of a vane were calculated from previous measurements of dynamic internal pressure in four chambers surrounding a vane. Next, the lubrication modes were distinguished with Hooke's chart, which is an improvement over Johnson's chart. Finally, the influence of the boundary conditions in the lubrication region on the fluid film lubrication was examined by calculating the film pressure distributions. The results showed that the lubrication mode of the vane tip exists in the rigid-variable-viscosity region, and that discharge pressure higher than 7 MPa greatly affects the oil film pressure in the small and the large arc section because of the Piezo-viscous effect.

引用

页码：1716 / 1721

页数：6

共 4 条

[1] Lubrication characteristics of the vane tip under inlet pressure boundary conditions for an oil hydraulic vane pump [J].