Effect of swirling vanes on performance of steam water jet injector

被引：15

作者：

Yan, Junjie ^{[1
]}

Chong, DaoTong ^{[1
]}

Wu, XinZhuang ^{[1
]}

机构：

[1] Xi An Jiao Tong Univ, State Key Lab Multiphase Flow Power Engn, Xian 710049, Peoples R China

来源：

APPLIED THERMAL ENGINEERING | 2010年 / 30卷 / 6-7期

基金：

中国国家自然科学基金;

关键词：

Steam-water jet injector; Swirling vanes; Entrainment ratio; Resistance coefficient; Exergy efficiency; COMPUTATIONAL FLUID-DYNAMICS; PUMP; PREDICTION;

D O I：

10.1016/j.applthermaleng.2009.11.007

中图分类号：

O414.1 [热力学];

学科分类号：

摘要：

The effect of water swirling vanes and steam swirling vanes on the steam-water jet injector with central water nozzle was experimentally investigated. The performance of the steam-water jet injector with water/steam swirling vanes was compared with that without swirling vanes. The exergy analysis was also carried out. According to the experimental results and analysis, the water swirling vanes could effectively enhance the performance of the jet injector, but the steam swirling vanes weakened the performance of the jet injector. When the water swirling vanes were equipped, the maximum amplitudes of increase in the entrainment ratio and exergy efficiency were 172% and 93%, respectively, and the highest inlet water temperature increased from 70 degrees C to 80 degrees C. The performance of steam-water jet injector with water swirling vanes was also investigated. The results showed that the entrainment ratio decreased with the increase of the inlet water pressure and temperature, and increased with the increase of inlet steam pressure. The resistance coefficients increased with the increase of the inlet water pressure and temperature, and decreased with the increase of inlet steam pressure. (C) 2009 Elsevier Ltd. All rights reserved.

引用

页码：623 / 630

页数：8

共 18 条

[1] High-pressure steam-driven jet pump - Part I: Mathematical modeling [J].

Beithou, N ;

Aybar, HS .

JOURNAL OF ENGINEERING FOR GAS TURBINES AND POWER-TRANSACTIONS OF THE ASME, 2001, 123 (03) :693-700

[2] High-pressure steam-driven jet pump - Part II: Parametric analysis [J].

Beithou, N ;

Aybar, HS .

JOURNAL OF ENGINEERING FOR GAS TURBINES AND POWER-TRANSACTIONS OF THE ASME, 2001, 123 (03) :701-706

[3] A SINGLE-STAGE HIGH-PRESSURE STEAM INJECTOR FOR NEXT-GENERATION REACTORS - TEST-RESULTS AND ANALYSIS [J].

CATTADORI, G ;

GALBIATI, L ;

MAZZOCCHI, L ;

VANINI, P .

INTERNATIONAL JOURNAL OF MULTIPHASE FLOW, 1995, 21 (04) :591-606

[4] Influence of the ejector configuration, scale and the gas density on the mass transfer characteristics of gas-liquid ejectors [J].

Cramers, PHMR ;

Beenackers, AACM .

CHEMICAL ENGINEERING JOURNAL, 2001, 82 (1-3) :131-141

[5] Influence of viscosity and surface tension on performance of gas-liquid contactors with ejector type gas distributor [J].

Elgozali, A ;

Linek, V ;

Fialová, M ;

Wein, O ;

Zahradník, J .

CHEMICAL ENGINEERING SCIENCE, 2002, 57 (15) :2987-2994

[6] Experimental investigation of heat transfer during condensation of steam from a steam-water mixture on cold water jets at high pressure [J].

Eroshkina E.V. ;

Kisina V.I. ;

Shvarts A.L. ;

Kolbasnikov A.V. .

Thermal Engineering, 2007, 54 (01) :55-60

[7] Submerged gas jet into a liquid bath: A review [J].

Gulawani, S. S. ;

Deshpande, S. S. ;

Joshi, J. B. ;

Shah, M. S. ;

Prasad, C. S. R. ;

Shukla, D. S. .

INDUSTRIAL & ENGINEERING CHEMISTRY RESEARCH, 2007, 46 (10) :3188-3218

[8]

Isachenko P., 1971, Teploenergetika, V18, P7

[9]

Isachenko P., 1972, Teploenergetika, V19, P24

[10]

Isachenko V.P., 1976, TEPLOENERGETIKA, V23, P72

← 1 2 →