X-ray-based measurement of composition during electron beam melting of AISI 316 stainless steel: Part II. Evaporative processes and simulation

An energy dispersive X-ray (EDX) detector mounted on a laboratory scale electron beam furnace (30 kW) was employed to assess the potential use of X-rays as a means of on-line composition monitoring during electron beam (E B) melting of alloys. The design and construction of the collimation and protection systems used for the EDX are described in Part I. In Part 11, a mathematical simulation of the heat, mass, and momentum transfer was performed for comparison to the EDX and vapor deposition results. The predicted flow patterns and evaporation rates are used to explain the differences between the two experimental methods. For the EDX spectra measured, the X-rays generated were from the center of the hearth where fluid flow rising from the bulk of the pool is sufficient to maintain the bulk composition despite the high evaporative flux from the surface. The flow moves radially outward from the center of the pool, with the volatile species being depleted. The vapor deposition technique measures the entire region, giving an average surface composition, and it therefore differs from the EDX results, which gave a near bulk composition. This combined study using in-situ EDX measurements and numerical simulations both provided an insight into the phenomena controlling the evaporation in an EB-heated system and demonstrated the viability of using EDX to measure the bulk composition during EB melting processes.