alternative fuels;
natural gas;
direct injection;
diesel pilot ignition;
injection pressure;
D O I:
10.1115/1.2432894
中图分类号:
TH [机械、仪表工业];
学科分类号:
0802 ;
摘要:
This study investigated the effects of injection pressure on the performance and emissions of a pilot-ignited, late-cycle direct-injected natural gas fueled heavy-duty engine. The experiments, conducted on a single-cylinder engine, covered a wide range of engine speeds, loads, and exhaust gas recirculation fractions. The injection pressure was varied at each operating condition while all other parameters were held constant. At high loads, increasing the injection pressure substantially reduced particulate matter and CO emisions ,with small increases in NOx and no significant effect on hydrocarbon emissions or fuel consumption. At low loads, injection pressure had no significant impact on either emissions or performance. At high loads, higher injection pressures consistently reduced both the number density and the size of particles in the exhaust stream. Injection pressure had reduced effects at increased engine speeds.
机构:
Chalmers Univ Technol, Combust Engine Res Ctr CERC, Horsalsvagen 7B, S-41296 Gothenburg, SwedenChalmers Univ Technol, Combust Engine Res Ctr CERC, Horsalsvagen 7B, S-41296 Gothenburg, Sweden
Babayev, Rafig
Andersson, Arne
论文数: 0引用数: 0
h-index: 0
机构:
Volvo Grp Trucks Technol Volvo GTT, Powertrain Strateg Dev PSD, Gothenburg, SwedenChalmers Univ Technol, Combust Engine Res Ctr CERC, Horsalsvagen 7B, S-41296 Gothenburg, Sweden
Andersson, Arne
Dalmau, Albert Serra
论文数: 0引用数: 0
h-index: 0
机构:
Volvo Grp Trucks Technol Volvo GTT, Powertrain Strateg Dev PSD, Gothenburg, SwedenChalmers Univ Technol, Combust Engine Res Ctr CERC, Horsalsvagen 7B, S-41296 Gothenburg, Sweden
Dalmau, Albert Serra
Im, Hong G.
论文数: 0引用数: 0
h-index: 0
机构:
King Abdullah Univ Sci & Technol KAUST, Clean Combust Res Ctr CCRC, Thuwal, Saudi ArabiaChalmers Univ Technol, Combust Engine Res Ctr CERC, Horsalsvagen 7B, S-41296 Gothenburg, Sweden
Im, Hong G.
Johansson, Bengt
论文数: 0引用数: 0
h-index: 0
机构:
Chalmers Univ Technol, Combust Engine Res Ctr CERC, Horsalsvagen 7B, S-41296 Gothenburg, SwedenChalmers Univ Technol, Combust Engine Res Ctr CERC, Horsalsvagen 7B, S-41296 Gothenburg, Sweden
机构:
School of Mechanical and Manufacturing Engineering, University of New South Wales, Sydney, 2052, NSWSchool of Mechanical and Manufacturing Engineering, University of New South Wales, Sydney, 2052, NSW
Wan Q.
Zhai G.
论文数: 0引用数: 0
h-index: 0
机构:
School of Mechanical and Manufacturing Engineering, University of New South Wales, Sydney, 2052, NSWSchool of Mechanical and Manufacturing Engineering, University of New South Wales, Sydney, 2052, NSW
Zhai G.
Wang C.
论文数: 0引用数: 0
h-index: 0
机构:
School of Mechanical and Manufacturing Engineering, University of New South Wales, Sydney, 2052, NSWSchool of Mechanical and Manufacturing Engineering, University of New South Wales, Sydney, 2052, NSW
Wang C.
Yuen A.C.Y.
论文数: 0引用数: 0
h-index: 0
机构:
School of Mechanical and Manufacturing Engineering, University of New South Wales, Sydney, 2052, NSWSchool of Mechanical and Manufacturing Engineering, University of New South Wales, Sydney, 2052, NSW
Yuen A.C.Y.
Medwell P.R.
论文数: 0引用数: 0
h-index: 0
机构:
School of Mechanical Engineering, The University of Adelaide, Adelaide, 5005, SASchool of Mechanical and Manufacturing Engineering, University of New South Wales, Sydney, 2052, NSW
Medwell P.R.
Kook S.
论文数: 0引用数: 0
h-index: 0
机构:
School of Mechanical and Manufacturing Engineering, University of New South Wales, Sydney, 2052, NSWSchool of Mechanical and Manufacturing Engineering, University of New South Wales, Sydney, 2052, NSW
Kook S.
Yeoh G.H.
论文数: 0引用数: 0
h-index: 0
机构:
School of Mechanical and Manufacturing Engineering, University of New South Wales, Sydney, 2052, NSWSchool of Mechanical and Manufacturing Engineering, University of New South Wales, Sydney, 2052, NSW
Yeoh G.H.
Chan Q.N.
论文数: 0引用数: 0
h-index: 0
机构:
School of Mechanical and Manufacturing Engineering, University of New South Wales, Sydney, 2052, NSWSchool of Mechanical and Manufacturing Engineering, University of New South Wales, Sydney, 2052, NSW
机构:
Newcastle Univ, Sir Joseph Swan Inst Energy Res, Newcastle Upon Tyne NE1 7RU, Tyne & Wear, EnglandNewcastle Univ, Sir Joseph Swan Inst Energy Res, Newcastle Upon Tyne NE1 7RU, Tyne & Wear, England
Antunes, J. M. Gomes
Mikalsen, R.
论文数: 0引用数: 0
h-index: 0
机构:
Newcastle Univ, Sir Joseph Swan Inst Energy Res, Newcastle Upon Tyne NE1 7RU, Tyne & Wear, EnglandNewcastle Univ, Sir Joseph Swan Inst Energy Res, Newcastle Upon Tyne NE1 7RU, Tyne & Wear, England
Mikalsen, R.
Roskilly, A. P.
论文数: 0引用数: 0
h-index: 0
机构:
Newcastle Univ, Sir Joseph Swan Inst Energy Res, Newcastle Upon Tyne NE1 7RU, Tyne & Wear, EnglandNewcastle Univ, Sir Joseph Swan Inst Energy Res, Newcastle Upon Tyne NE1 7RU, Tyne & Wear, England