Thermoplastic 3D Printing-An Additive Manufacturing Method for Producing Dense Ceramics

被引：109

作者：

Scheithauer, Uwe ^{[1
]}

Schwarzer, Eric ^{[1
]}

Richter, Hans-Juergen ^{[1
]}

Moritz, Tassilo ^{[1
]}

机构：

[1] Fraunhofer Inst Ceram Technol & Syst IKTS, D-01277 Dresden, Germany

来源：

INTERNATIONAL JOURNAL OF APPLIED CERAMIC TECHNOLOGY | 2015年 / 12卷 / 01期

基金：

欧盟地平线“2020”;

关键词：

LASER; COMPONENTS; SCAFFOLDS;

D O I：

10.1111/ijac.12306

中图分类号：

TQ174 [陶瓷工业]; TB3 [工程材料学];

学科分类号：

0805 ; 080502 ;

摘要：

In our new approach-thermoplastic 3D printing-a high-filled ceramic suspension based on thermoplastic binder systems is used to produce dense ceramic components by additive manufacturing. Alumina (67 vol%) and zirconia (45 vol%) suspensions were prepared by ball milling at a temperature of about 100 degrees C to adjust a low viscosity. After the preparation the suspension solidified at cooling. For the sintered samples (alumina at 1600 degrees C, zirconia at 1500 degrees C), a density of about 99% and higher was obtained. FESEM studies of the samples' cross section showed a homogenous microstructure and a very good bond between the single printed layers.

引用

页码：26 / 31

页数：6

共 34 条

[1] Processing of advanced electroceramic components by fused deposition technique [J].