3-D numerical analysis for fluid flow and heat transfer in a micro chip by using an electro-hydrodynamic micro-pump

A computational investigation of the heat transfer for a high performance integrated chip by using an electrohydrodynamic (EHD) pump was studied. This paper presents a fully computational system bundle with electro field, fluid flow and heat transfer for a cooling device. The micro pump provides the required pumping power by using the dipole moment generated from polarizing molecules and induces the flow to cool down the heat source. The computational domain of the micro channel for length and depth are kept in 1500 mu m and 500 mu m with parallel electrodes pitch (20 mu m, 40 mu m, 80 mu m). The effects of different applied voltage V-E ranging from 100V to 500V, using oil as the working fluid and the heat flux of the heat source fixed at 2.5W/cm(2) is investigated in detail. It is found that the EHD micro pump is more effective for lower channel pitch and higher applied voltage. For V-E = 500V and electrodes pitch = 20 mu m, this study identifies a maximum performance of 49.36kPa in the pressure head and 9.55W/cm(2) in the heat transfer. In addition, the performance of flow rate, liquid velocity and averaging Nusselt number for the specific condition are 0.94 L/min-mm(2), 0.12 m/s, and 106.10. However, it also identifies the performance of the heat transfer for electrodes pitch = 40 mu m is about 146.0% of that for pitch = 80 mu m. But for pitch = 20 mu m, it is only 10.5% higher than that for pitch = 40 mu m.