Improving the efficiency of layered perovskite cathodes by microstructural optimization

Low-temperature solid oxide fuel cells require the use of cathodes with improved performance. In this context, microstructural optimization is fundamental in order to obtain more efficient and stable materials. However, most of the current fabrication techniques involve multiple steps and therefore they are not suitable for industrial applications. This report describes alternative strategies to prepare PrBaCo2O5+ d (PBC) cathodes by using a simple and economic spray-pyrolysis deposition (SP) method. Three different electrode configurations have been tested: (i) PBC prepared by spray-pyrolysis on dense CGO pellets, (ii) PBC deposited onto porous CGO backbone layers and (iii) submicrometric PBC powders prepared from freeze-dried precursors and deposited by a screen-printing process. The second approach is an alternative to the traditional wet infiltration method with a number of advantages, such as a shorter preparation time and simplicity of implementation at industrial scale. Reduced values of polarization resistance (R-p) are obtained at 600 degrees C, 0.027 Omega cm(2) for SP electrodes on porous CGO backbones, in comparison to 0.22 U cm2 for submicrometric powder cathodes by screen-printing. Moreover, SP electrodes demonstrate improved stability with stable R-p values at 650 degrees C over time. A Ni-CGO anode-supported cell with an SP cathode achieves a remarkable peak power density of 0.95 W cm(-2) at 600 degrees C in comparison to 0.6 W cm(-2) for the cell with a screen-printed cathode.