Characterization of an integrated micro heat pipe

被引:22
|
作者
Lee, M [1 ]
Wong, M
Zohar, Y
机构
[1] Hong Kong Univ Sci & Technol, Dept Engn Mech, Kowloon, Hong Kong, Peoples R China
[2] Hong Kong Univ Sci & Technol, Dept Elect & Elect Engn, Kowloon, Hong Kong, Peoples R China
关键词
D O I
10.1088/0960-1317/13/1/309
中图分类号
TM [电工技术]; TN [电子技术、通信技术];
学科分类号
0808 ; 0809 ;
摘要
The characterization of a micro heat pipe system, integrated with a local heater, temperature and capacitive microsensors is presented. Two liquid charging schemes based on a single hole, requiring vacuum environment, and a pair of holes, utilizing capillary forces are compared. Taking advantage of the great disparity between the dielectric constants of liquids and gases, capacitance sensors are used for void fraction measurements. Since it is difficult to control the phase content of a liquid-gas mixture in a micro heat pipe, a calibration technique based on a traveling water-air interface due to evaporation is introduced. The integrated sensor capacitance for pure water is found to depend on measurement frequency, temperature and ion concentration, exhibiting trends that are different front previous reports. The measured temperature and void fraction distribution along the heat pipes are consistent with the two-phase flow patterns recorded during the microsystem operation.
引用
收藏
页码:58 / 64
页数:7
相关论文
共 50 条
  • [1] Design, fabrication and characterization of an integrated micro heat pipe
    Lee, M
    Wong, M
    Zohar, Y
    FIFTEENTH IEEE INTERNATIONAL CONFERENCE ON MICRO ELECTRO MECHANICAL SYSTEMS, TECHNICAL DIGEST, 2002, : 85 - 88
  • [2] Integrated micro-heat-pipe fabrication technology
    Lee, M
    Wong, M
    Zohar, Y
    JOURNAL OF MICROELECTROMECHANICAL SYSTEMS, 2003, 12 (02) : 138 - 146
  • [3] Polymer micro-heat-pipe for InP/InGaAs integrated circuits
    Liu, WY
    Mohammadi, S
    Katehi, LPB
    NINETEENTH ANNUAL IEEE SEMICONDUCTOR THERMAL MEASUREMENT AND MANAGEMENT SYMPOSIUM, 2003, : 82 - 87
  • [4] Investigation into the performance of a micro gravitational heat pipe and a micro gravitational heat pipe with artery
    Riffat, SB
    Zhao, X
    Doherty, PS
    INTERNATIONAL JOURNAL OF ENERGY RESEARCH, 2003, 27 (01) : 45 - 61
  • [5] Characterization of thermal behavior of a micro pulsating heat pipe by local heat transfer investigation
    Iwata, Naoko
    Bozzoli, Fabio
    Pagliarini, Luca
    Cattani, Luca
    Vocale, Pamela
    Malavasi, Matteo
    Rainieri, Sara
    INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER, 2022, 196
  • [6] Experimental study on high-power LEDs integrated with micro heat pipe
    LI C.-M.
    Zhou C.-P.
    Luo Y.
    Hamidnia M.
    Wang X.-D.
    You B.
    Optoelectronics Letters, 2016, 12 (1) : 31 - 34
  • [7] Experimental study on high-power LEDs integrated with micro heat pipe
    李聪明
    周传鹏
    罗怡
    Mohammad Hamidnia
    王晓东
    由博
    OptoelectronicsLetters, 2016, 12 (01) : 31 - 34
  • [8] Performance characterization of a novel flat plate micro heat pipe spreader
    Kalahasti, S
    Joshi, YK
    IEEE TRANSACTIONS ON COMPONENTS AND PACKAGING TECHNOLOGIES, 2002, 25 (04): : 554 - 560
  • [9] Heat Transfer Limitation of a Micro Heat Pipe
    Shukla, K. N.
    JOURNAL OF ELECTRONIC PACKAGING, 2009, 131 (02) : 0245021 - 0245023
  • [10] Integrated design of solar photovoltaic photothermal building based on micro heat pipe array
    Wan Li
    Liu Chengpeng
    2022 IEEE INTERNATIONAL CONFERENCE ON ELECTRICAL ENGINEERING, BIG DATA AND ALGORITHMS (EEBDA), 2022, : 1010 - 1013