Characterization of the dissolution of the Al2Cu phase in two Al-Si-Cu-Mg casting alloys using calorimetry

被引：73
作者：
Lasa, L
Rodriguez-Ibabe, JM
机构：
[1] CEIT, Dept Mat, San Sebastian 20018, Basque Country, Spain
[2] Univ Navarra, ESII San Sebastian, San Sebastian 20018, Basque Country, Spain
来源：
MATERIALS CHARACTERIZATION | 2002年 / 48卷 / 05期
关键词：
Al2Cu phase; calorimetry; thixoforming;
D O I：
10.1016/S1044-5803(02)00283-8
中图分类号：
T [工业技术];
学科分类号：
08 ;
摘要：
The dissolution of Al2CU in two Al-Si-Mg-Cu aluminum alloys was investigated by calorimetric analysis and metallographic measurements. Both alloys had similar compositions but very different microstructures. Alloy A was produced by gravity casting and alloy B by thixoforming, The main goal of this research was to analyze the possibility of monitoring the dissolution of the Al2CU phase through calorimetric analysis, relating the dissolution of this intermetallic phase with energy variations of the endothermic peaks during differential scanning calorimeter runs. The results obtained were in agreement with metallographic measurements. (C) 2002 Elsevier Science Inc. All rights reserved.
引用
收藏
页码：371 / 378
页数：8
相关论文
共 18 条
[1]   Effects of thermal treatments on microstructure and mechanical properties in a thixocast 319 aluminum alloy [J].
Cerri, E ;
Evangelista, E ;
Spigarelli, S ;
Cavaliere, P ;
DeRiccardis, F .
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING, 2000, 284 (1-2) :254-260
[2]  
Davies JR, 1993, ASM specialty handbook: aluminum and aluminum alloys, P290
[3]   THE EFFECT OF SILICON CONTENT AND MORPHOLOGY ON THE WEAR OF ALUMINUM-SILICON ALLOYS UNDER DRY AND LUBRICATED SLIDING CONDITIONS [J].
DAVIS, FA ;
EYRE, TS .
TRIBOLOGY INTERNATIONAL, 1994, 27 (03) :171-181
[4]   Strength and toughness of semi-solid processed hypereutectic Al/Si alloys [J].
Goni, JV ;
RodriguezIbabe, JM ;
Urcola, JJ .
SCRIPTA MATERIALIA, 1996, 34 (03) :483-489
[5]  
GUPTA AK, 1987, MATER SCI TECH SER, V3, P1012, DOI 10.1179/026708387790329397
[6]  
GUPTA AK, 1989, MATER SCI TECH SER, V5, P52, DOI 10.1179/026708389790337495
[7]   Effect of processing on the microstructural variation and heat-treatment response of a hypereutectic Al-Si alloy [J].
Gupta, M ;
Lavernia, EJ .
JOURNAL OF MATERIALS PROCESSING TECHNOLOGY, 1995, 54 (1-4) :261-270
[8]  
KAPRANOS P, 2000, INT C SEM PROC ALL C, P741
[9]   Effect of composition and processing route on the wear behaviour of Al-Si alloys [J].
Lasa, L ;
Rodriguez-Ibabe, JM .
SCRIPTA MATERIALIA, 2002, 46 (06) :477-481
[10]  
Mondolfo L.F., 1976, ALUMINUM ALLOYS STRU, P644
12