Experimental Investigation into Hydraulic Fracture Network Propagation in Gas Shales Using CT Scanning Technology

Multistage fracturing of the horizontal well is recognized as the main stimulation technology for shale gas development. The hydraulic fracture geometry and stimulated reservoir volume (SRV) is interpreted by using the microseismic mapping technology. In this paper, we used a computerized tomography (CT) scanning technique to reveal the fracture geometry created in natural bedding-developed shale (cubic block of 30 cm x 30 cm x 30 cm) by laboratory fracturing. Experimental results show that partially opened bedding planes are helpful in increasing fracture complexity in shale. However, they tend to dominate fracture patterns for vertical stress difference Delta sigma (v) a parts per thousand currency sign 6 MPa, which decreases the vertical fracture number, resulting in the minimum SRV. A uniformly distributed complex fracture network requires the induced hydraulic fractures that can connect the pre-existing fractures as well as pulverize the continuum rock mass. In typical shale with a narrow (< 0.05 mm) and closed natural fracture system, it is likely to create complex fracture for horizontal stress difference Delta sigma (h) a parts per thousand currency sign 6 MPa and simple transverse fracture for Delta sigma (h) a parts per thousand yen 9 MPa. However, high naturally fractured shale with a wide open natural fracture system (> 0.1 mm) does not agree with the rule that low Delta sigma (h) is favorable for uniformly creating a complex fracture network in zone. In such case, a moderate Delta sigma (h) from 3 to 6 MPa is favorable for both the growth of new hydraulic fractures and the activation of a natural fracture system. Shale bedding, natural fracture, and geostress are objective formation conditions that we cannot change; we can only maximize the fracture complexity by controlling the engineering design for fluid viscosity, flow rate, and well completion type. Variable flow rate fracturing with low-viscosity slickwater fluid of 2.5 mPa s was proved to be an effective treatment to improve the connectivity of induced hydraulic fracture with pre-existing fractures. Moreover, the simultaneous fracturing can effectively reduce the stress difference and increase the fracture number, making it possible to generate a large-scale complex fracture network, even for high Delta sigma (h) from 6 MPa to 12 MPa.